Room BTU Calculator

Room BTU Calculator

Select the room conditions to determine the required BTU.

BTU Result
|◀ 1417 - 1428 of 1647 ▶|
View:
  • Single stage cooling capacity control on all 072-241 models
  • Two stage cooling capacity control on all 120-240 models
  • Round copper tube aluminum plate fin (RTPF) condenser coils on all models
  • Brass suction and liquid line service valves
  • Full perimeter base rail with built-in rigging adapters and fork truck slots
  • Galvanized steel cabinet with pre-painted exterior panels and primer-coated
  • interior panels tested to 500 hours salt spray protection
  • Fully hermetic scroll compressor with crankcase heater
  • Compressor mounted on independent vibration isolators
  • Comfort AlertTM Diagnostic Board
  • LED Go-No-Go and fault code
  • Built in time guard anti-short cycle
  • Phase protection
  • Fault code retention logic
  • Low volt compressor contactor Protector
  • All units have high and low pressure switches
  • Direct drive permanently lubricated condenser fan motors
  • Newly designed terminal board facilitates simple safety circuit
    troubleshooting and simplified control box arrangement
  • Outdoor temperature cooling operation range up to 125°F (52°C) and down to 40°F (4°C ) using winter start kit
  • Models with optional low ambient control provide cooling operation down to -20°F (-29°C )
  • All units factory run tested

    International Comfort Products CAS151HAA0A00A

  • Item#:
    CAS151HAA0A00A
    Manufacturer Item:
    CAS151HAA0A00A
    Manufacturer:
    INTERNATIONAL COMFORT PRODUCTS
    Easy-to-Install and Service
  • Environmentally balanced R410A refrigerant
  • Scroll compressor standard on all models
  • Copper tube/aluminum fin condenser coil
  • Aluminum tube/aluminum fin evaporator coil
  • Dehumidification mode (airflow reduction) on all models
  • Dense wire grille on all models
  • Pre-painted steel cabinet
  • Induced-draft combustion and venting
  • Direct spark ignition
  • High efficiency ECM indoor blower motor on all models
  • Stainless steel tubular heat exchanger
  • Vertical condenser fan discharge
  • Full perimeter steel base rails
  • High and low pressure switches provide added reliability for the compressor
  • Three-year No Hassle Replacement limited warranty
  • Lifetime heat exchanger limited warranty with timely registration
  • Five-year parts limited warranty  With timely registration, an additional five-year parts limited warranty * For residential applications only. See warranty certificate for complete details and restrictions, including warranty coverage for other applications.
  • Installs easily on a rooftop or at ground level
  • Easy threepanel accessibility for maintenance and installation
  • Easily converts to down discharge applications
  • Combination gas heating, heat pump heating and electric coolin

    International Comfort Products PDD460115K000K

  • Item#:
    PDD460115K000K
    Manufacturer Item:
    PDD460115K000K
    Manufacturer:
    INTERNATIONAL COMFORT PRODUCTS
    Easy-to-Install and Service
  • Environmentally balanced R410A refrigerant
  • Scroll compressor standard on all models
  • Copper tube/aluminum fin condenser coil
  • Aluminum tube/aluminum fin evaporator coil
  • Dehumidification mode (airflow reduction) on all models
  • Dense wire grille on all models
  • Pre-painted steel cabinet
  • Induced-draft combustion and venting
  • Direct spark ignition
  • High efficiency ECM indoor blower motor on all models
  • Stainless steel tubular heat exchanger
  • Vertical condenser fan discharge
  • Full perimeter steel base rails
  • High and low pressure switches provide added reliability for the compressor
  • Three-year No Hassle Replacement limited warranty
  • Lifetime heat exchanger limited warranty with timely registration
  • Five-year parts limited warranty  With timely registration, an additional five-year parts limited warranty * For residential applications only. See warranty certificate for complete details and restrictions, including warranty coverage for other applications.
  • Installs easily on a rooftop or at ground level
  • Easy threepanel accessibility for maintenance and installation
  • Easily converts to down discharge applications
  • Combination gas heating, heat pump heating and electric coolin

    International Comfort Products PDD424060K000K

  • Item#:
    PDD424060K000K
    Manufacturer Item:
    PDD424060K000K
    Manufacturer:
    INTERNATIONAL COMFORT PRODUCTS
  • REFRIGERATION CIRCUIT
  • Environmentally sound R-410A refrigerant
  • Liquid refrigerant filter driers
  • Copper tube/aluminum fin condenser and evaporator coils
  • EASY TO INSTALL AND SERVICE
  • Light weight, compact construction ideal for manufactured housing and residential applications
  • Hand holds built into the unit base pan
  • Compact, fully self-contained, electric cooling unit with horizontal supply and return ducts
  • Easy panel accessibility for maintenance and installation
  • Accessory electric heaters with single point connections
  • Designed to be serviced from both the side and front

    International Comfort Products PAJ424000K000K

  • Item#:
    PAJ424000K000K
    Manufacturer Item:
    PAJ424000K000K
    Manufacturer:
    INTERNATIONAL COMFORT PRODUCTS
  • Cost-competitive
  • Available in 115V and 208/230V
  • Built-in basepan heater on heat pump units
  • Auto-restart function
  • Condenser high-temperature protection
  • Refrigerant leakage detection
  • Quiet outdoor operation, as low as 52 dB(A)
  • Anti-corrosive fin coating
  • Piping length 82 ~ 164 ft. (25-50 m.)
  • Cooling operating range 0° ~ 22° F (-17° ~ 50° C)
  • Heating operating range 0° ~ 86° F (-17° ~ 30° C)

    International Comfort Products DLCSRBH09AAK

  • Item#:
    DLCSRBH09AAK
    Manufacturer Item:
    DLCSRBH09AAK
    Manufacturer:
    INTERNATIONAL COMFORT PRODUCTS
    International Comfort Products DLFSHBH09XAK Ductless Mini-Split Indoor Wall Mounted 9K BTU 230 VAC

    International Comfort Products DLFSHBH09XAK

    Item#:
    DLFSHBH09XAK
    Manufacturer Item:
    DLFSHBH09XAK
    Manufacturer:
    INTERNATIONAL COMFORT PRODUCTS
    Standard Features
  • R-410A Chlorine-Free Refrigerant
  • Intelligent Oil Return Technology
  • Inverter Driven Rotary Compressor
  • Crankcase Heater Standard Multiple System Protection:
  • High pressure switch and low pressure transducer
  • Compressor liquid return protection
  • Compressor high or low compression ratio protection
  • Compressor high temperature protection
  • High / low voltage protection and over current protection
  • IPM and electronic control board high temperature protection
  • Outdoor coil is capable of withstanding 1000 hour salt spray test according to ASTM B117 standard
  • AHRI certified; ETL listed

    Bosch BRCA-60HWD1N1-M15

  • Item#:
    BRCA-60HWD1N1-M15
    Manufacturer Item:
    8-733-957-162
    Manufacturer:
    BOSCH THERMOTECHNOLOGY CORP
  • Single stage cooling capacity control on all 072-241 models
  • Two stage cooling capacity control on all 120-240 models
  • Round copper tube aluminum plate fin (RTPF) condenser coils on all models
  • Brass suction and liquid line service valves
  • Full perimeter base rail with built-in rigging adapters and fork truck slots
  • Galvanized steel cabinet with pre-painted exterior panels and primer-coated
  • interior panels tested to 500 hours salt spray protection
  • Fully hermetic scroll compressor with crankcase heater
  • Compressor mounted on independent vibration isolators
  • Comfort AlertTM Diagnostic Board
  • LED Go-No-Go and fault code
  • Built in time guard anti-short cycle
  • Phase protection
  • Fault code retention logic
  • Low volt compressor contactor Protector
  • All units have high and low pressure switches
  • Direct drive permanently lubricated condenser fan motors
  • Newly designed terminal board facilitates simple safety circuit
    troubleshooting and simplified control box arrangement
  • Outdoor temperature cooling operation range up to 125°F (52°C) and down to 40°F (4°C ) using winter start kit
  • Models with optional low ambient control provide cooling operation down to -20°F (-29°C )
  • All units factory run tested

    International Comfort Products CAS183HTA0A00A

  • Item#:
    CAS183HTA0A00A
    Manufacturer Item:
    CAS183HTA0A00A
    Manufacturer:
    INTERNATIONAL COMFORT PRODUCTS
  • Single stage cooling capacity control on all 072-241 models
  • Two stage cooling capacity control on all 120-240 models
  • Round copper tube aluminum plate fin (RTPF) condenser coils on all models
  • Brass suction and liquid line service valves
  • Full perimeter base rail with built-in rigging adapters and fork truck slots
  • Galvanized steel cabinet with pre-painted exterior panels and primer-coated
  • interior panels tested to 500 hours salt spray protection
  • Fully hermetic scroll compressor with crankcase heater
  • Compressor mounted on independent vibration isolators
  • Comfort AlertTM Diagnostic Board
  • LED Go-No-Go and fault code
  • Built in time guard anti-short cycle
  • Phase protection
  • Fault code retention logic
  • Low volt compressor contactor Protector
  • All units have high and low pressure switches
  • Direct drive permanently lubricated condenser fan motors
  • Newly designed terminal board facilitates simple safety circuit
    troubleshooting and simplified control box arrangement
  • Outdoor temperature cooling operation range up to 125°F (52°C) and down to 40°F (4°C ) using winter start kit
  • Models with optional low ambient control provide cooling operation down to -20°F (-29°C )
  • All units factory run tested

    International Comfort Products CAS181LAA0A0AA

  • Item#:
    CAS181LAA0A0AA
    Manufacturer Item:
    CAS181LAA0A0AA
    Manufacturer:
    INTERNATIONAL COMFORT PRODUCTS
  • Single stage cooling capacity control on all 072-241 models
  • Two stage cooling capacity control on all 120-240 models
  • Round copper tube aluminum plate fin (RTPF) condenser coils on all models
  • Brass suction and liquid line service valves
  • Full perimeter base rail with built-in rigging adapters and fork truck slots
  • Galvanized steel cabinet with pre-painted exterior panels and primer-coated
  • interior panels tested to 500 hours salt spray protection
  • Fully hermetic scroll compressor with crankcase heater
  • Compressor mounted on independent vibration isolators
  • Comfort AlertTM Diagnostic Board
  • LED Go-No-Go and fault code
  • Built in time guard anti-short cycle
  • Phase protection
  • Fault code retention logic
  • Low volt compressor contactor Protector
  • All units have high and low pressure switches
  • Direct drive permanently lubricated condenser fan motors
  • Newly designed terminal board facilitates simple safety circuit
    troubleshooting and simplified control box arrangement
  • Outdoor temperature cooling operation range up to 125°F (52°C) and down to 40°F (4°C ) using winter start kit
  • Models with optional low ambient control provide cooling operation down to -20°F (-29°C )
  • All units factory run tested

    International Comfort Products CAS183LTA0A00A

  • Item#:
    CAS183LTA0A00A
    Manufacturer Item:
    CAS183LTA0A00A
    Manufacturer:
    INTERNATIONAL COMFORT PRODUCTS
  • Single stage cooling capacity control on all 072-241 models
  • Two stage cooling capacity control on all 120-240 models
  • Round copper tube aluminum plate fin (RTPF) condenser coils on all models
  • Brass suction and liquid line service valves
  • Full perimeter base rail with built-in rigging adapters and fork truck slots
  • Galvanized steel cabinet with pre-painted exterior panels and primer-coated
  • interior panels tested to 500 hours salt spray protection
  • Fully hermetic scroll compressor with crankcase heater
  • Compressor mounted on independent vibration isolators
  • Comfort AlertTM Diagnostic Board
  • LED Go-No-Go and fault code
  • Built in time guard anti-short cycle
  • Phase protection
  • Fault code retention logic
  • Low volt compressor contactor Protector
  • All units have high and low pressure switches
  • Direct drive permanently lubricated condenser fan motors
  • Newly designed terminal board facilitates simple safety circuit
    troubleshooting and simplified control box arrangement
  • Outdoor temperature cooling operation range up to 125°F (52°C) and down to 40°F (4°C ) using winter start kit
  • Models with optional low ambient control provide cooling operation down to -20°F (-29°C )
  • All units factory run tested

    International Comfort Products CAS091LGA0A00A

  • Item#:
    CAS091LGA0A00A
    Manufacturer Item:
    CAS091LGA0A00A
    Manufacturer:
    INTERNATIONAL COMFORT PRODUCTS
  • Single stage cooling capacity control on all 072-241 models
  • Two stage cooling capacity control on all 120-240 models
  • Round copper tube aluminum plate fin (RTPF) condenser coils on all models
  • Brass suction and liquid line service valves
  • Full perimeter base rail with built-in rigging adapters and fork truck slots
  • Galvanized steel cabinet with pre-painted exterior panels and primer-coated
  • interior panels tested to 500 hours salt spray protection
  • Fully hermetic scroll compressor with crankcase heater
  • Compressor mounted on independent vibration isolators
  • Comfort AlertTM Diagnostic Board
  • LED Go-No-Go and fault code
  • Built in time guard anti-short cycle
  • Phase protection
  • Fault code retention logic
  • Low volt compressor contactor Protector
  • All units have high and low pressure switches
  • Direct drive permanently lubricated condenser fan motors
  • Newly designed terminal board facilitates simple safety circuit
    troubleshooting and simplified control box arrangement
  • Outdoor temperature cooling operation range up to 125°F (52°C) and down to 40°F (4°C ) using winter start kit
  • Models with optional low ambient control provide cooling operation down to -20°F (-29°C )
  • All units factory run tested

    International Comfort Products CAS121LMA0A00A

  • Item#:
    CAS121LMA0A00A
    Manufacturer Item:
    CAS121LMA0A00A
    Manufacturer:
    INTERNATIONAL COMFORT PRODUCTS
    |◀ 1417 - 1428 of 1647 ▶|
    View: