Brand Name
Horsepower
Voltage
Phase
Amperage
Part Type
|◀ 1 - 12 of 179 ▶|
View:
TPI LRD100A Thermostat, 120 - 277 VAC, 0 - 110 deg F
  • 3/4 hp at 125 VAC, 1.5 hp at 250 - 277 VAC, 14 ga leads
  • 6 feet capillary length
Item#:
LDR100A
Manufacturer Item:
LRD100A
Manufacturer:
TPI CORPORATION
RectorSeal® EZT-113B Economy Trap Kit with Brush, 3/4 Inch, 8-1/2 Inch Sid Harvey Item #:EZT-113B: Replaces Part #:'s : B13-547
Item#:
EZT-113B
Manufacturer Item:
EZT113B
Manufacturer:
E Z TRAP INC.
Diversitech EcoPad EP2424-2 Equipment Pad, 24 Inch L x 24 Inch W x 2 Inch D, Plastic, Domestic
  • 173 lb estimated allowable load
  • Used mainly as a base pad for ground supported equipment
  • Unlike other plastic pads, EnviroPad rugged design provides uniform and generous ribbing for optimum self-leveling ground support without inserts
  • The pads should be installed on roughly leveled soil or ground
  • EnviroPad equipment pads, due to their plastic composition, are not recommended for use in applications requiring pad contact with excessive heat or open flame
  • Enclosed is a table showing the allowable load estimates
  • Both 2 and 3 Inch pads have the same weight capacity
Item#:
EP2424-2
Manufacturer Item:
EP2424-2
Manufacturer:
CONDENSER PADS
A solid state control designed to help prevent flooding, damage to carpets, walls, furniture, ceilings, etc. Now has a built-in test and reset button for easier installation. Turns system off when detecting moisture due to condensate or drain leaks. 1 or 2 drops will cause wet switch to turn off a unit, alerting a serviceman to a moisture problem. A lit LED indicates the wet switch is activated and has turned the unit off. Reset simply by drying the absorbent pad with a paper towel and pressing the reset switch. Connects to 24 VAC. More than 1 unit may be connected to a system.
  • Integral feet raise the hydrophilic pad and sensor array off the drain pan slightly to prevent nuisance tripping and pan corrosion (metal pans only) from interfering with the sensor array
  • A high tech polymeric fiber quickly draws water into the sensor array using proven capillary technology
  • Multiple unit connectivity allows for multiple Wet Switches to be connected in series to adequately cover large drain pan areas
  • The standard power available on most air handler units, this makes hook-up quick and easy, there is no need to run different power to the switch
  • The double throw relay allows for wiring to interrupt the system and to sound an alarm (by others) when moisture is detected
  • A high tech array of multiple stainless steel sensors detects even a minimal amount of water drawn into the hydrophilic pad
  • Proven electronics prevent mechanical failure in an aggressive operating environment
  • When the wet switch activates, it locks out the call for cool circuit on the air conditioner until the switch is manually reset, this prevents continuing damage in cases where the overflow water drains out of the pan, onto the surrounding ceiling
  • The push to test button on wet switch gives the installer a quick, easy way to test the wiring on their installation, giving you the confidence the switch will work as designed, when needed
  • This technology is packed into a hockey puck sized 3-5/8 Inch diameter by 1-1/4 Inch high cylinder, furnished complete with 5-conductor 22 AWG stranded cable, 6 feet long
Sid Harvey Item #:WS-1: Replaces Part #:'s : 29045
Item#:
WS-1
Manufacturer Item:
WS-1
Manufacturer:
DIVERSITECH CORP
The E397-300BM raises the condensing unit above the floor for protection from dirt, snow, debris, floods and other perils. It is made from heavy duty steel with a powder-coated finish. Features an adjustable width cross bar and a level for ease of installation.
  • Powder-coated Steel
  • Hardware included for most installations, 4 rubber vibration absorbing pads and level
  • 1 Year Warranty
Item#:
E397-300BM
Manufacturer Item:
E397-300BM
Manufacturer:
MITCO MFG.
RectorSeal® Safe-T-Switch SS2 PVC Low Voltage A/C Condensate Overflow The Safe-T-Switch model SS2 detects down stream clogs in condensate drains and interrupts the thermostat circuit to shut off the unit before flooding occurs. Works with optional Safe-T-Gard model SG1 condensate overflow alarm. The model SS2 is designed for installation on auxiliary drain pan outlets - usually on primary condensate drain pans. PVC slip L body accepts a 3/4 Inch PVC pipe or stub adaptor. Compact footprint fits well in tight spaces. Approved for use as a substitute for auxiliary condensate drains in jurisdictions where the international mechanical code applies.
Item#:
SS2-1
Manufacturer Item:
SS2
Manufacturer:
RECTORSEAL
The AguaGuard AG-1200+ offers all of the same industry leading features of the AquaGuard 1100+ magnetic float switch plus an innovatively designed two-piece clamp, which allows it to be mounted to either the side of a metal secondary drain pan or the rolled edge of a plastic secondary drain pan. The AquaGuard AG-1200+ has a trigger sensitivity of less than 1/2 in of condensate overflow.
  • High capacity 5 amp, 24 VAC sensor
  • Easy, drill-free installation
  • Lift float pin test knob
  • Protective housing keeps out insulation, pests and debris
  • Normally open 3rd wire for optional external alarm, digital controller or energy management systems
  • The AG-1100+ is incredibly easy to install, it can be mounted to the drain pan in 10 sec or less, installation does not require any pre-drilling for screws
  • The AG-1100+ incorporates a Protective cover to keep out insulation and debris that could prevent the float from rising
Sid Harvey Item #:AG-1200: Replaces Part #:'s : 2R034A
Item#:
AG-1200
Manufacturer Item:
96106
Manufacturer:
AQUAGUARD
The SL series line of exact replacement heavy-duty sealed bimetal disc controls meets the higher electrical requirements of commercial applications. Can handle electrical loads up to 25 A at 120/240VAC.
Item#:
SL5709
Manufacturer Item:
SL5709
Manufacturer:
SEALED UNIT PARTS CO, INC
Temprite 62028000 Steel and Borosilicate Glass Standard Filter Kit, 14 Inch L x 3-1/2 Inch Dia.
Item#:
62028000
Manufacturer Item:
62028000
Manufacturer:
TEMPRITE
Suitable for many applications, the SmartTrap line offers the most comprehensive range of transparent condensate traps with float switch overflow protection. This trap can be used for most applications requiring a automatic shut down. Includes a standard clear u-bend for inspection and access ports for easy cleaning.
  • 1 Inch drop
Sid Harvey Item #:EZT-210: Replaces Part #:'s : 39952
Item#:
EZT-210
Manufacturer Item:
EZT-210
Manufacturer:
E Z TRAP INC.
EcoPad equipment pads are made from injection molded plastic. Their application is mainly as a base pad for ground supported equipment. Unlike other plastic pads, EcoPad rugged design provides uniform and generous ribbing for optimum self-leveling ground support without inserts. The pads should be installed on roughly leveled soil or ground. EcoPad equipment pads, due to their plastic composition, are not recommended for use in applications requiring pad contact with excessive heat or open flame.
  • Outer edges have rounded corners with double-thick walls
  • Textured surface prevents equipment slippage
  • UV resistant and unaffected by weather
  • Uniform ribbing transfers load evenly
  • No cracking and less breakage than concrete
  • Drillable for securing equipment
  • Extremely durable, yet lightweight
  • Generous ribbing for optimum, self-leveling ground support
  • Made of recycled material
Item#:
EP3030-2
Manufacturer Item:
EP3030-2
Manufacturer:
CONDENSER PADS
JB Industries The Shield SHLD-P4 Straight Refrigerant Locking Cap, 1/4 With the rise of refrigerant theft and huffing related deaths, it is now code to protect your air conditioning unit's refrigerant. The American made SHIELD Refrigerant Locking Cap does just that by saving homeowners money and helping avoid liability issues by shielding them from theft, tampering, leaking and huffing related injuries. The SHIELD's durable, all brass design paired with color coded, water-proof caps makes it the best locking cap in the industry.
Item#:
SHLD-P4
Manufacturer Item:
SHLD-P4
Manufacturer:
JB INDUSTRIES
|◀ 1 - 12 of 179 ▶|
View: