R80-32R

R80-30R

• Immersion type Aquastat controller and oil burner primary control provides high limit and low limit/circulator control for oil-fired hydronic heating systems
• Use in intermittent ignition applications
• Capable of zone control with zone valves
• Circulator zone control with ZC and ZR terminals on R8182D, E, H, J
• 8-flame failure during the running cycle results in a 45 sec attempt to restart
• If unsuccessful, safety shutoff occurs, requiring manual reset before burner can be restarted
• C554A cadmium sulfide flame detector and a 24 VAC thermostat required
• Includes auxiliary ZC and ZR terminals may be used to provide circulator zone control through an R845A switching relay, horizontal case
• Maximum 250 deg F at element, 15 deg F fixed high limit differential temperature
• 45 sec safety switch timing
• 1/2"-14 NPT well spud size
• 0.2 amp anticipator setting
• 1-1/2" insulation depth,
  
  

  R80-58R

Interrupted ignition type
• Combine a Protectorelay unit for cycling the burner and a Pyrostat flame detector for sensing temperature changes of flue gases up to 1000 deg F
• Manual reset of safety switch required after ignition failure completely shuts off main burner
• Include manual trip safety switch to assure burner shutdown during servicing
• Mount with flange for mounting on curved or flat surfaces
• Works with 2-wire and 3-wire 24 VAC thermostat
• 2 years warranty
  
  

  R22R

• Ignition comes on for duration of safety timing if flame fails during operation
  
  

  R75-61R

Skuttle L26-24

R75-58R

• Remanufactured with 100% pure, solid silver Pyrostat contacts for longer on-the-job service life
• Backed by 2-year warranty
• All new stack relays contain brass contacts covered with a slight silver plating, it wears off as the contacts open and close, exposing the brass surface over time, the exposed surface is a poor conductor and may result in relay failure and nuisance callbacks
  
  

  R5R

Controls oil burner, oil valve (if desired) and the ignition transformer in response to a call for heat
• Solid state flame sensing circuit
• LED on terminal strip indicates system lockout Remote lockout indication
• Enclosed safety switch with external reset button
• Manual trip lever opens safety switch for system maintenance
• Mounts on standard 4 x 4" junction box
• C554A cadmium sulfide flame detector and 24 VAC thermostat required
• With 30 sec safety timing, alarm outputs and manual safety switch
  
  

  R75-42R

R75-41R

Controls oil burner, oil valve (if desired) and the ignition transformer in response to a call for heat
• Solid state flame sensing circuit
• LED on terminal strip indicates system lockout
• Remote lockout indication
• Enclosed safety switch with external reset button
• Manual trip lever opens safety switch for system maintenance
• Mounts on standard 4 x 4" junction box
• C554A cadmium sulfide flame detector and 24 VAC thermostat required
• With 15 sec safety timing, alarm outputs and manual safety switch

R75-40R