• Quick hook-up fittings provided
• Lever operated, full port ball valve for easy blow down
• Adjustable Bx outlet for easy installation
• Dual precision switches for dependable operation of cut-off, alarm or electric water feeder Mcdonnell & Miller 67 Mechanical Low Water Cut-Off, 120/240 VAC, 20 psi, Automatic Reset,
  
  

  Sid Harvey Remanufactured B103R

Sid Harvey Remanufactured B109R

• Uses rectification principle of electronic flame detection
• Primary control provides solid state, electronic flame safeguard protection for industrial and commercial single or dual fuel burners for rectification type flame detection
• Recycles if flame signal lost while in run, failure to establish pilot results in a lockout
• Safe-start check prevents start-up if flame-simulating failure occurs in flame detector circuit
• Includes built-in protection against ignition crossover in flame rod systems
• Solid state circuitry
• Mounts and removes easily through use of captive mounting screws
• Mounting base is made of strong thermoplastic
• Includes SPDT alarm contacts Honeywell Protectorelay RA890F1288 Flame Safeguard Primary Control, 120 VAC at 50/60 Hz, SPDT
  
  

  Sid Harvey Remanufactured R202-52R

Sid Harvey Remanufactured R176-6R

Sid Harvey Remanufactured R202-46R

Sid Harvey Remanufactured R216-18R

Sid Harvey Remanufactured C293-3R

• ,
  
  

  Sid Harvey Remanufactured C434-9R

Sid Harvey Remanufactured C434-7R

• The PA404 is a series 40 (2-wire, SPST) pressuretrol controller for use in 24, 120, 240 or 277 volt control circuits or in self powered (millivoltage) applications
• The PA404B is used with suspension-type unit heaters to make the fan circuit when a pressure rise indicates the presence of steam
• Each model contains an SPST micro-switch snap-acting switch
• Sensitive pressure-actuated diaphragm expands or contracts with pressure variations, moving a lever mechanism which operates the snap switch
• A screw on top of the case allows set point adjustment without removing the cover
• Differential is adjusted by means of a dial located inside the case
• Recommended minimum set point is differential setting plus 1-1/2 psi
• Tradeline value
• Stainless steel diaphragm sensor element
• Additive or subtractive differential type
• Makes at set point plus differential on pressure rise, breaks at set point on pressure fall
• 50 psi pressure surge
• 0.5-9 psi adjustable scale range,
  
  

  Sid Harvey Remanufactured C354-1R

Sid Harvey Remanufactured C322-4R

Immersion-type controllers that combine high limit protection with low limit and circulator control in forced hydronic heating systems
• Require 24 VAC thermostat with heat anticipator set at 0.2 amp (plus current draw of gas valve on L8124E)
• Include diaphragm powerhead and micro Switch assembly that respond to temperature changes in boiler water
• Mount directly to boiler
• Provide multi-zone control by using a separate circulator and R845 relay for each zone
• Electrical burner rating: full load - 7.4 amp at 120 VAC line voltage, 3.7 amp at 240 VAC; locked rotor - 44.4 amp at 120 VAC line voltage, 22.7 amp at 240 VAC
• Electrical circulator rating: 7.4 amp at 120 VAC, 3.7 amp at 240 VAC full load; 44.4 amp at 120 VAC, 22.2 amp at 240 VAC locked rotor

Sid Harvey Remanufactured C317-8R