Home  > WILLIAMSON -THERMOFLO(x)
View:
Williamson -Thermoflo Parts 386700847WT OWT-4 Flue Top Kit

    Williamson -Thermoflo Parts 386700847WT

Item#:
386700847WT
Manufacturer Item:
386-700-847WT
Manufacturer:
WILLIAMSON -THERMOFLO
Williamson-Thermoflo OWB-3-T-S2-W 3-Section Cast Iron Residential Oil Fired Water Boiler, 85-86.4% AFUE, 98K BTU-133 BTU Input, 86K-114K BTU Output, Less Coil, Less Burner.
  • Factory tested
  • Easy service
  • Swing-away burner door
  • Low draft loss
  • Top access cleanout cover
  • Plug-in wiring harness
  • High efficiency oil burner
  • Flame retention head design
  • Solenoid valve
  • PSC motor
  • Solid state ignitor
  • Rear flue outlet
  • Cast iron sections with built-in air separator
  • Insulated heavy-gauge steel jacket

Williamson -Thermoflo OWB-3-T-S2-W

Item#:
OWB-3-T-S2-W
Manufacturer Item:
OWB-3-T-S2-W
Manufacturer:
WILLIAMSON -THERMOFLO
Williamson-Thermoflo CHB-105-DD-X-W-S2 Powder Coat Paint Oil Furnace, 85.9% AFUE, 91000/105000/119000 BTU Input, 79100/89400/101100 BTU Output, 1300 cfm
  • Less burner
  • Front flue with top or right side venting option
  • Interior baffling for maximum efficiency
  • 3.5 Ton cooling capacity
  • Heavy gauge with seal-tite construction and foil-faced insulation for hand-cool surface
  • Spring loaded observation port with test port
  • 21" width x 20" depth supply air outlet
  • 15" width x 22" depth return air outlet
  • 6" flue diameter
  • Heavy gauge burner mounting plate with studs and nuts
  • Fully enclosed burner and controls
  • Preformed slide out chamber for easy service
Item#:
CHB105DDXWS2
Manufacturer Item:
CHB105DDXWS2
Manufacturer:
WILLIAMSON -THERMOFLO
Williamson-Thermoflo TCOIL-OSB Tankless Coil for OSB Series oil fired

Williamson -Thermoflo TCOIL-OSB

Item#:
TCOIL-OSB
Manufacturer Item:
TCOIL-OSB
Manufacturer:
WILLIAMSON -THERMOFLO
Williamson-Thermoflo GL-42-W Glass Lined Indirect Fired Water Heater, 39.9 Gallon Domestic, 1.7 Gallon Boiler, 8 gpm at 1.6 feet WC, 125 BTU
  • Inspection opening provides easy access to clean and inspect tank
  • 2" of dense foam insulation, CFC free and environmentally safe
  • Adjustable leveling legs
  • low off cycle losses
  • Pressure relief valve provided
  • Tank and coil are 100% air pressure/water tested
  • Factory installed sacrificial magnesium anode rod
  • 10-years residential and 7-years commercial warranty

Williamson -Thermoflo GL-42-W

Item#:
GL-42-W
Manufacturer Item:
GL-42-W
Manufacturer:
WILLIAMSON -THERMOFLO
Williamson-Thermoflo CLB-105-DD-R-X-W-S2 Powder Coat Paint Oil Furnace, 85.9% AFUE, 91000/105000/119000 BTU Input, 79400/90200/101200 BTU Output, 1325 cfm
  • Less burner
  • Rear flue
  • Interior baffling for maximum efficiency
  • 3.5 Ton cooling capacity
  • Heavy gauge with seal-tite construction and foil-faced insulation for hand-cool surface
  • Spring loaded observation port with test port
  • 18-1/2" width x 17-1/2" depth supply air outlet
  • 18-1/2" width x 15-1/2" depth return air outlet
  • 6" flue diameter
  • Heavy gauge burner mounting plate with studs and nuts
  • Heavy-gauge with seal-tite construction
  • Preformed slide out chamber for easy service
Item#:
CLB105DDRXWS2
Manufacturer Item:
CLB105DDRXWS2
Manufacturer:
WILLIAMSON -THERMOFLO
Williamson-Thermoflo CLB-105-DD-F-X-W-S2 Powder Coat Paint Oil Furnace, 85.9% AFUE, 91000/105000/119000 BTU Input, 79400/90200/101200 BTU Output, 1325 cfm
  • Less burner
  • Front flue
  • Interior baffling for maximum efficiency
  • 3.5 Ton cooling capacity
  • Heavy gauge with seal-tite construction and foil-faced insulation for hand-cool surface
  • Spring loaded observation port with test port
  • 18-1/2" width x 17-1/2" depth supply air outlet
  • 18-1/2" width x 15-1/2" depth return air outlet
  • 6" flue diameter
  • Heavy gauge burner mounting plate with studs and nuts
  • Heavy-gauge with seal-tite construction
  • Preformed slide out chamber for easy service
Item#:
CLB105DDFXWS2
Manufacturer Item:
CLB105DDFXWS2
Manufacturer:
WILLIAMSON -THERMOFLO
Weil-McLain Parts 381800476WT Vent Damper 6"

    Weil-McLain Parts 381800476WT

Item#:
381800476WT
Manufacturer Item:
381-800-476WT
Manufacturer:
WILLIAMSON -THERMOFLO
Williamson-Thermoflo GSA-100-N-IP Cast Iron Natural Gas Fired Steam Boiler, 82.9% AFUE, 100K BTU Input 62K BTU Output
  • Factory tested
  • Easy service - 1-piece access door, all controls in easy reach
  • High efficiency - generous heating surface, automatic vent damper
  • Rugged construction for long life, stainless steel burners, integral cast iron legs, integral draft diverter, insulated heavy gauge steel jacket, heavy gauge aluminized steel flue collector
  • 24 VAC combination gas valve
  • Gauge glass and guard assembly
  • Pressure gauge and siphon assembly
  • Pressure limit control
  • Probe low water cut-off
  • High temperature limit control
  • 15 psig ASME relief valve
  • Drain valve
  • Spark ignited (intermittent) pilot system, electronic ignition/flame supervisory control
  • 10 years limited warranty on boiler sections, 1 year limited warranty on parts

Williamson -Thermoflo GSA-100-N-IP

Item#:
GSA-100-N-IP
Manufacturer Item:
GSA-100-N-IP
Manufacturer:
WILLIAMSON -THERMOFLO
Williamson-Thermoflo CLB-140-DD-R-X-W-S2 Powder Coat Paint Oil Furnace, 85.9% AFUE, 140000 BTU Input, 120000 BTU Output, 1800 cfm
  • Less burner
  • Rear flue
  • Interior baffling for maximum efficiency
  • 5 Ton cooling capacity
  • Heavy gauge with seal-tite construction and foil-faced insulation for hand-cool surface
  • Spring loaded observation port with test port
  • 22-3/4" width x 21-1/4" depth supply air outlet
  • 22-3/4" width x 13-1/2" depth return air outlet
  • 7" flue diameter
  • Heavy gauge burner mounting plate with studs and nuts
  • Heavy-gauge with seal-tite construction
  • Preformed slide out chamber for easy service
Item#:
CLB140DDRXWS2
Manufacturer Item:
CLB140DDRXWS2
Manufacturer:
WILLIAMSON -THERMOFLO
Williamson-Thermoflo PMP-098-DD-W Powder Coat Paint Stainless Steel Oil Furnace, 86.4% AFUE, 70000/84000/98000 BTU Input, 58000/69000/81000 BTU Output, 1350 cfm
  • Multi-position installation
  • Low profile
  • Heavy gauge stainless steel primary heat exchanger and tube style aluminized steel secondary heat exchanger with removable baffles
  • 16" width x 19" depth supply air outlet
  • 19" height x 19" depth return air outlet
  • 5" flue diameter
  • Large front access clean out secured with studs and nuts
  • Rugged cabinet
  • Slide-out blower/motor
Item#:
PMP098DDW
Manufacturer Item:
PMP098DDW
Manufacturer:
WILLIAMSON -THERMOFLO
Williamson-Thermoflo CHB-105-VS-S2-W Powder Coat Paint Oil Furnace, 85.9% AFUE, 91000/105000/119000 BTU Input, 79100/89400/101100 BTU Output, 1300 cfm
  • Front flue with top or right side venting option
  • Interior baffling for maximum efficiency
  • 3.5 Ton cooling capacity
  • Heavy gauge with seal-tite construction and foil-faced insulation for hand-cool surface
  • Spring loaded observation port with test port
  • 21" width x 20" depth supply air outlet
  • 15" width x 22" depth return air outlet
  • 6" flue diameter
  • Heavy gauge burner mounting plate with studs and nuts
  • Fully enclosed burner and controls
  • Preformed slide out chamber for easy service
Item#:
CHB-105-VS-S2-W
Manufacturer Item:
CHB105VSS2W
Manufacturer:
WILLIAMSON -THERMOFLO
View: