Industry Standard R-410A Refrigerant

Models featuring Electric Heat without Indoor Cooling Coil

Quiet and efficient X-13 (ECM) motor technology

Only 35" tall and 4-way convertible for all those tight spaces

Available from factory in upflow and horizontal configurations

Nominal airflow up to 0.5" external static pressure with reduced airflow up to 1.0" external static pressure

Factory installed MultiFlex coils

Sturdy steel construction with 1 inch [25.4 mm] of foil faced insulation for excellent sound and insulating characteristics

Permanent, easily accessible and washable filter furnished standard

Circuit breaker (standard on units with more than 11 kW) meets U.L. and cUL requirements for service disconnect

Factory installed auxiliary electric heat provides exact heat for indoor comfort over a variety of applications

Fan settings for selectable, customized cooling airflow over a wide variety of applications

Cabinet air leakage less than 2% at 1 inch H2O when tested in accordance with ASHRAE standard 193

Fujitsu Heating Parts FETST601SYS Econet Controller

FETST601SYS

Fujitsu FF40173TS92M Gas Furnace 40K BTU 92% AFUE Constant Torque Motor Multi-Pos Not Down-Flow 17"W,
,

Fujitsu FF40173TS92M

Fujitsu FF40173TS92M

Fujitsu FH4821TPSASN 1-Stage Standard Efficiency 95% Non-Communicating Air Handler
The most compact unit design available, all standard heat airhandler models only 421/2 to 57"es [1079 to 1448 mm] high. Attractive pre-painted cabinet exterior. Rugged wall steel cabinet construction, designed for added strength and versatility. 1.0" foil faced insulation mechanically retained in blower compartment for excellent thermal and sound performance. Four leg blower motor mount. Blower housing with controls, motor and blower. Slide out design for service and maintenance convenience. Traditional open wire element design for heat applications. Field convertible for vertical downflow, horizontal left hand or right hand air supply. 3 combustible floor base accessories fit all model sizes when required for downflow installations on combustible floors. Indoor coil design provides low air side pressure drop, high performance and extremely compact size. Expansion valve on indoor coil provides for operation with air conditioning or heat pump using the same coil. Coils are constructed of aluminum fins bonded to internally grooved aluminum tubing. Coils are tested at the factory with an extensive refrigerant leak check.Coils have copper sweat refrigerant connections.Coils utilize chatleff metering device connections. Molded polymer corrosion resistant condensate drain pan is provided on all indoor coils. Supply duct flanges provided as standard on air handler cabinet. Provisions for field electrical, connections available from either side or top of the air handler cabinet. Connection point for high voltage wiring is inside the air handler cabinet. Low voltage connection is made on the outside of the air handler cabinet. Concentric knockouts are provided for power connection to cabinet. Installer may pull desired hole size up to 2"es [51 mm] for 11/2" [38 mm] conduit. Front refrigerant and drain connections

48K BTU 4 Ton
• 115/1 VAC
• 21" Wide
• PSC Motor
• Multi-Position,
  FUJITSU FH4821TPSJSN
  
  

  FUJITSU FH4821TPSJSN