• Low cost 3 PH protection for single side
• Monitors for phase reversal, phase loss, unbalance % as a function of input VAC age
• Bright LED indicators for ON and FAULT
• 115, 208/230 VAC control VAC age input
• Epoxy encapsulated for moisture protection
• Easy to install, no adjustment
• Less than 1 sec phase loss response
• Automatic reset from a fault condition
• Compact packaging - fits almost anywhere
• Works great with the ICM450 for load side monitoring of part winding start motors and multiple compressor systems

ICM Controls ICM402

• Heavy-duty heat relay
• Integral short cycle protection
• Micro-processor based fan blower control
• Purges ducts of residual air

ICM Controls ICM275C

• Easy installation
• Low cost, high performance
• Rugged, reliable
• L-L, L-N, L-G, N-G AC protection modes
• Electrical panel/disconnect installation point
• Green light indicates surge suppression present
• NEMA Type 3R waterproof metal enclosure

ICM Controls ICM517

• Easy installation
• Low cost, high performance
• Rugged, reliable
• 3/4" conduit connection
• Green light indicates surge suppression present
• Installation point - electrical panel, inside electrical disconnect

ICM Controls ICM516

ICM Controls ICM870-16A

• Protects against over and under VAC age and rapid short cycling caused by transient faults and power interruptions
• Easy view, backlit digital display
• RMS VAC age set point
• Adjustable VAC age set point
• Adjustable over VAC age setting
• Adjustable under VAC age setting
• Adjustable anti-short cycle time delay
• Adjustable response time
• Control mode
• Universal line VAC age input
• Heavy duty SPDT relay output
• Universal control VAC age input (for integrating a thermostat)

ICM Controls ICM492C

ICM Controls ICM492D

ICM Controls ICM333

ICM Controls ICM450A

• Low cost open board design
• High power, relay output
• Dual function fan delay timer
• Off delay purges ducts of residual air
• On delay allows air to reach the proper comfort level prior to energizing the fan

ICM Controls ICM255C

• Low cost, time and temperature defrost
• Time and temperature terminate
• 30/60/90 min pin-selectable intervals time
• Test pins reduce test time by 256x
• High power output (1 HP at 240 VAC )
• Integral short cycle protection
• 5 min anti-short cycle time
• 30/60/90 min interval times
• SPST relay
• Direct replacement for Nordyne 621301A/621579B/621579C/917178, ICM DFORB-AB1004
• 10 min fixed defrost time

ICM Controls ICM302

• Micro-processor-based fan blower
• Direct replacement for Goodman 800442010359/B1370735S/PCBFM131S

ICM Controls ICM277C