honeywell c554a1463

Right angle boot on the igniter end and a straight boot on the module end



Honeywell G565-38

The M847D is a two position, 24 VAC spring return actuators designed to operate ARD, EARD and ZD zone dampers
• Low voltage, spring return damper actuators
• Equipped with anti-rotation and drive shaft extensions for direct mounting to 7 or 16" diameter coupling style dampers
• Adjustable range stops
  
  

  L408J1009

L404F1078

L404F1060

The M847D is a two position, 24 VAC spring return actuators designed to operate ARD, EARD and ZD zone dampers
• Low voltage, spring return damper actuators
• Equipped with anti-rotation and drive shaft extensions for direct mounting to 7 or 16 Inch diameter coupling style dampers
• Adjustable range stops
  
  

  Honeywell M847D-VENT

The M847D is a two position, 24 VAC spring return actuators designed to operate ARD, EARD and ZD zone dampers
• Low voltage, spring return damper actuators
• Equipped with anti-rotation and drive shaft extensions for direct mounting to 7 or 16 Inch diameter coupling style dampers
• Adjustable range stops
• Direct replacement for M847D1004
  
  

  Honeywell M847D-ZONE

HONEYWELL PV-001RP

Operate outdoor air dampers for combustion or makeup air in residential and light commercial applications
• Operate changeover dampers for heating and cooling systems
• Operate minimum position dampers for ventilation and similar applications
• Spring returns motor to start position on power failure
• Drive shafts located on both sides of motor
• Adjustable auxiliary switch for cascading motors or operating auxiliary equipment
• Thermal breaker for overload protection during lifting stroke or if motor stalls
  
  

  HONEYWELL R242-10

Solid state plug-in amplifiers that respond to flame detector inputs to indicate the presence of flame when used with 7800 series relay modules
• Flame failure response time of 2 or 3 sec
• Flame signal strength ranges from 0 - 5 VDC
• Plug into 7800 relay module through printed circuit board edge connector keyed for proper orientation
• Flame signal test jacks to measure amplifier flame signal voltage
• Color coded labels identify flame detection type
• Dynamic self-check amplifier test the detectors and all electronic components in the flame detection system 7800 series relay module locks out on safety shutdown with flame detection system failure
• Compatible with existing Honeywell flame detectors
• Use with flame sensor gas rectifying flame rods C7004, C7005, C7007, C7008, C7009, Q179; gas, oil, coverall Length ultraviolet flame sensor C7012A
  
  

  honeywell r7847a1033

R550-280

honeywell s9200u1000