|◀ 721 - 732 of 864 ▶|
View:
Baked-On Powder Coated Hydronic Air Handler with TXV Metering
  • Multi function micro-processor circuit board
  • Blower start relay - eliminates field installed boiler relay, allowing direct wiring from the boiler to the air handler
  • Manual air vent on hot water coil
  • Blower door shut-off switch
  • Slide out hot water coil for easier service
  • 2-speed fan operation
  • Convertible horizontal drain pan
  • PisTon type metering device (standard)
  • Copper tube heating and cooling coils
  • Compatible with all major brands of split condensing units and heat pumps
  • Primary and secondary condensate drain connections
  • Factory installed filter drier
  • 1" filter easily accessible
  • Without pump

    First Company 48HCXB-HW-TXV410

Item#:
48HCXB-HW-TXV410
Manufacturer Item:
48HCXB-HW-TXV410
Manufacturer:
FIRST CO.
Baked-On Powder Coated Hydronic Air Handler with TXV Metering
  • Multi function micro-processor circuit board
  • Blower start relay - eliminates field installed boiler relay, allowing direct wiring from the boiler to the air handler
  • Manual air vent on hot water coil
  • Blower door shut-off switch
  • Slide out hot water coil for easier service
  • 2-speed fan operation
  • Convertible horizontal drain pan
  • PisTon type metering device (standard)
  • Copper tube heating and cooling coils
  • Compatible with all major brands of split condensing units and heat pumps
  • Primary and secondary condensate drain connections
  • Factory installed filter drier
  • 1" filter easily accessible
  • Without pump

    First Company 60HCXB-HW-R410A-TXV

Item#:
60HCXB-HW-R410A-TXV
Manufacturer Item:
6060H3HW4X
Manufacturer:
FIRST CO.
STANDARD Features
  • 3-way airflow (except 60/61HCX)
  • Factory installed horizontal drain pan
  • Completely prewired with 0-25kW electric heat (except 0kW models)
  • Compatible with major brands of split condensing units and heat pumps (Contact factory for correct match with outdoor unit)
  • Piston-type metering device or factory or field installed TXV (non-bleed type) on cooling coil
  • Factory installed filter
  • Attractive baked on finish
  • Copper tube cooling coils
  • Primary and secondary drain connections on cooling coil
  • Fully insulated and painted galvanized steel cabinet
  • Factory installed disconnect switch (over 10kW models)

    First Company 60HCXW3010BVB00AAF

  • Item#:
    60HCXW3010BVB00AAF
    Manufacturer Item:
    6060W3010BVB00AAF
    Manufacturer:
    FIRST CO.
  • Single stage cooling capacity control on all 072-241 models
  • Two stage cooling capacity control on all 120-240 models
  • Round copper tube aluminum plate fin (RTPF) condenser coils on all models
  • Brass suction and liquid line service valves
  • Full perimeter base rail with built-in rigging adapters and fork truck slots
  • Galvanized steel cabinet with pre-painted exterior panels and primer-coated
  • interior panels tested to 500 hours salt spray protection
  • Fully hermetic scroll compressor with crankcase heater
  • Compressor mounted on independent vibration isolators
  • Comfort AlertTM Diagnostic Board
  • LED Go-No-Go and fault code
  • Built in time guard anti-short cycle
  • Phase protection
  • Fault code retention logic
  • Low volt compressor contactor Protector
  • All units have high and low pressure switches
  • Direct drive permanently lubricated condenser fan motors
  • Newly designed terminal board facilitates simple safety circuit
    troubleshooting and simplified control box arrangement
  • Outdoor temperature cooling operation range up to 125°F (52°C) and down to 40°F (4°C ) using winter start kit
  • Models with optional low ambient control provide cooling operation down to -20°F (-29°C )
  • All units factory run tested

    International Comfort Products CAS072HAA0A00A

  • Item#:
    CAS072HAA0A00A
    Manufacturer Item:
    CAS072HAA0A00A
    Manufacturer:
    INTERNATIONAL COMFORT PRODUCTS
    Fujitsu RGEA14042ACT101AA Package Gas/Electric 3-1/2 Ton 230/3 14 SEER 33,600 BTUH Cooling,

    Fujitsu RGEA14042ACT101AA

    Item#:
    RGEA14042ACT101AA
    Manufacturer Item:
    RGEA14042ACT101AA
    Manufacturer:
    GENERAL HVAC SOLUTIONS AMERICA
    Standard Features
  • R-410A Chlorine-Free Refrigerant
  • Intelligent Oil Return Technology
  • Inverter Driven Rotary Compressor
  • Crankcase Heater Standard Multiple System Protection:
  • High pressure switch and low pressure transducer
  • Compressor liquid return protection
  • Compressor high or low compression ratio protection
  • Compressor high temperature protection
  • High / low voltage protection and over current protection
  • IPM and electronic control board high temperature protection
  • Outdoor coil is capable of withstanding 1000 hour salt spray test according to ASTM B117 standard
  • AHRI certified; ETL listed

    Bosch BRCA-60HWD1N1-M15

  • Item#:
    BRCA-60HWD1N1-M15
    Manufacturer Item:
    8-733-957-162
    Manufacturer:
    BOSCH THERMOTECHNOLOGY CORP
    Standard Features
  • R-410A Chlorine-Free Refrigerant
  • Intelligent Oil Return Technology
  • Inverter Driven Rotary Compressor
  • Crankcase Heater Standard Multiple System Protection:
  • High pressure switch and low pressure transducer
  • Compressor liquid return protection
  • Compressor high or low compression ratio protection
  • Compressor high temperature protection
  • High / low voltage protection and over current protection
  • IPM and electronic control board high temperature protection
  • Outdoor coil is capable of withstanding 1000 hour salt spray test according to ASTM B117 standard
  • AHRI certified; ETL listed

    Bosch BRCA-36HWD1N1-M15

  • Item#:
    BRCA-36HWD1N1-M15
    Manufacturer Item:
    8-733-957-161
    Manufacturer:
    BOSCH THERMOTECHNOLOGY CORP
  • Single stage cooling capacity control on all 072-241 models
  • Two stage cooling capacity control on all 120-240 models
  • Round copper tube aluminum plate fin (RTPF) condenser coils on all models
  • Brass suction and liquid line service valves
  • Full perimeter base rail with built-in rigging adapters and fork truck slots
  • Galvanized steel cabinet with pre-painted exterior panels and primer-coated
  • interior panels tested to 500 hours salt spray protection
  • Fully hermetic scroll compressor with crankcase heater
  • Compressor mounted on independent vibration isolators
  • Comfort AlertTM Diagnostic Board
  • LED Go-No-Go and fault code
  • Built in time guard anti-short cycle
  • Phase protection
  • Fault code retention logic
  • Low volt compressor contactor Protector
  • All units have high and low pressure switches
  • Direct drive permanently lubricated condenser fan motors
  • Newly designed terminal board facilitates simple safety circuit
    troubleshooting and simplified control box arrangement
  • Outdoor temperature cooling operation range up to 125°F (52°C) and down to 40°F (4°C ) using winter start kit
  • Models with optional low ambient control provide cooling operation down to -20°F (-29°C )
  • All units factory run tested

    International Comfort Products CAS091HGA0A00A

  • Item#:
    CAS091HGA0A00A
    Manufacturer Item:
    CAS091HGA0A00A
    Manufacturer:
    INTERNATIONAL COMFORT PRODUCTS
  • Single stage cooling capacity control on all 072-241 models
  • Two stage cooling capacity control on all 120-240 models
  • Round copper tube aluminum plate fin (RTPF) condenser coils on all models
  • Brass suction and liquid line service valves
  • Full perimeter base rail with built-in rigging adapters and fork truck slots
  • Galvanized steel cabinet with pre-painted exterior panels and primer-coated
  • interior panels tested to 500 hours salt spray protection
  • Fully hermetic scroll compressor with crankcase heater
  • Compressor mounted on independent vibration isolators
  • Comfort AlertTM Diagnostic Board
  • LED Go-No-Go and fault code
  • Built in time guard anti-short cycle
  • Phase protection
  • Fault code retention logic
  • Low volt compressor contactor Protector
  • All units have high and low pressure switches
  • Direct drive permanently lubricated condenser fan motors
  • Newly designed terminal board facilitates simple safety circuit
    troubleshooting and simplified control box arrangement
  • Outdoor temperature cooling operation range up to 125°F (52°C) and down to 40°F (4°C ) using winter start kit
  • Models with optional low ambient control provide cooling operation down to -20°F (-29°C )
  • All units factory run tested

    International Comfort Products CAS121HMA0A00A

  • Item#:
    CAS121HMA0A00A
    Manufacturer Item:
    CAS121HMA0A00A
    Manufacturer:
    INTERNATIONAL COMFORT PRODUCTS
  • Single stage cooling capacity control on all 072-241 models
  • Two stage cooling capacity control on all 120-240 models
  • Round copper tube aluminum plate fin (RTPF) condenser coils on all models
  • Brass suction and liquid line service valves
  • Full perimeter base rail with built-in rigging adapters and fork truck slots
  • Galvanized steel cabinet with pre-painted exterior panels and primer-coated
  • interior panels tested to 500 hours salt spray protection
  • Fully hermetic scroll compressor with crankcase heater
  • Compressor mounted on independent vibration isolators
  • Comfort AlertTM Diagnostic Board
  • LED Go-No-Go and fault code
  • Built in time guard anti-short cycle
  • Phase protection
  • Fault code retention logic
  • Low volt compressor contactor Protector
  • All units have high and low pressure switches
  • Direct drive permanently lubricated condenser fan motors
  • Newly designed terminal board facilitates simple safety circuit
    troubleshooting and simplified control box arrangement
  • Outdoor temperature cooling operation range up to 125°F (52°C) and down to 40°F (4°C ) using winter start kit
  • Models with optional low ambient control provide cooling operation down to -20°F (-29°C )
  • All units factory run tested

    International Comfort Products CAS091LGA0A00A

  • Item#:
    CAS091LGA0A00A
    Manufacturer Item:
    CAS091LGA0A00A
    Manufacturer:
    INTERNATIONAL COMFORT PRODUCTS
  • Single stage cooling capacity control on all 072-241 models
  • Two stage cooling capacity control on all 120-240 models
  • Round copper tube aluminum plate fin (RTPF) condenser coils on all models
  • Brass suction and liquid line service valves
  • Full perimeter base rail with built-in rigging adapters and fork truck slots
  • Galvanized steel cabinet with pre-painted exterior panels and primer-coated
  • interior panels tested to 500 hours salt spray protection
  • Fully hermetic scroll compressor with crankcase heater
  • Compressor mounted on independent vibration isolators
  • Comfort AlertTM Diagnostic Board
  • LED Go-No-Go and fault code
  • Built in time guard anti-short cycle
  • Phase protection
  • Fault code retention logic
  • Low volt compressor contactor Protector
  • All units have high and low pressure switches
  • Direct drive permanently lubricated condenser fan motors
  • Newly designed terminal board facilitates simple safety circuit
    troubleshooting and simplified control box arrangement
  • Outdoor temperature cooling operation range up to 125°F (52°C) and down to 40°F (4°C ) using winter start kit
  • Models with optional low ambient control provide cooling operation down to -20°F (-29°C )
  • All units factory run tested

    International Comfort Products CAS183HTA0A00A

  • Item#:
    CAS183HTA0A00A
    Manufacturer Item:
    CAS183HTA0A00A
    Manufacturer:
    INTERNATIONAL COMFORT PRODUCTS
  • Single stage cooling capacity control on all 072-241 models
  • Two stage cooling capacity control on all 120-240 models
  • Round copper tube aluminum plate fin (RTPF) condenser coils on all models
  • Brass suction and liquid line service valves
  • Full perimeter base rail with built-in rigging adapters and fork truck slots
  • Galvanized steel cabinet with pre-painted exterior panels and primer-coated
  • interior panels tested to 500 hours salt spray protection
  • Fully hermetic scroll compressor with crankcase heater
  • Compressor mounted on independent vibration isolators
  • Comfort AlertTM Diagnostic Board
  • LED Go-No-Go and fault code
  • Built in time guard anti-short cycle
  • Phase protection
  • Fault code retention logic
  • Low volt compressor contactor Protector
  • All units have high and low pressure switches
  • Direct drive permanently lubricated condenser fan motors
  • Newly designed terminal board facilitates simple safety circuit
    troubleshooting and simplified control box arrangement
  • Outdoor temperature cooling operation range up to 125°F (52°C) and down to 40°F (4°C ) using winter start kit
  • Models with optional low ambient control provide cooling operation down to -20°F (-29°C )
  • All units factory run tested

    International Comfort Products CAS181LAA0A0AA

  • Item#:
    CAS181LAA0A0AA
    Manufacturer Item:
    CAS181LAA0A0AA
    Manufacturer:
    INTERNATIONAL COMFORT PRODUCTS
    |◀ 721 - 732 of 864 ▶|
    View: