International Comfort Products Fast Parts CPRFCURB011A00 16 ga Steel Small Roof Curb, 78" L x 49" W x 14" H

International Comfort Products Fast A/C Parts CRRFCURB003A01

ICP Fast Heating Parts CRTWOPOS011A00 Motorrized Damper 2 Postion 7.5-12.5 Ton

ICP Fast Heating Parts CRTWOPOS011A00

International Comfort Products Fast Parts CRECOMZR074A01 Economizer Vertical/Horizontal Low Leak

International Comfort Products Fast A/C Parts CRECOMZR074A01

ICP Fast Heating Parts CRTWOPOS010A00 Motorrized Damper 2 Postion 2-6 Ton

ICP Fast Heating Parts CRTWOPOS010A00

International Comfort Products Fast Parts CRRFCURB001A01 16 ga Steel Flat Roof Curb, 67-3/8" L x 34-3/16" W x 14" H

International Comfort Products Fast A/C Parts CRRFCURB001A01

EWC Controls NCM 300 panel provides intelligent control of Heat Pump or Conventional forced air zoning systems at a maximum of three zones using motorized dampers and practically any off-the-shelf heat/cool thermostat. With features like automatic changeover, opposite system service, short cycle timers and supply air sensing capability, the NCM 300 provides a high level of performance in a non-expandable zone control panel.

• 2 - 3 zones, non-expandable
• Compatible equipment - gas/electric/hydro up to 2 stages heating and 1 stage cooling and heat pump conventional up to 2 stages heating and 1 stage cooling
• Compatible thermostat: Any single stage heat/cool thermostat or 2 stage heat, 1 stage cool heat pump thermostat
• Compatible damper - EWC models URD, ND, RSD and SID, any 24 VAC 3-wire or 2-wire damper
• Staging via adjustable on-board timer (7 - 42 min)
• Enhanced hydro-air capabilities, can delay fan activation on Heating demand
• Supply air temperature monitoring to help protect HVAC equipment
• Adjustable purge time (90 or 120 sec)
• On board LED's indicate system operation
• Supply Air Sensor

,

,

EWC Controls NCM300

The ND Damper is constructed using Heavy Duty 0.80 extruded aluminum.

Nylon Bearings for quiet operation.

Overlapping parallel blade design insures low leakage.

Designed to operate at static pressures up to 1.5 w.c.

The UL Listed Motor Actuator is a 24 vac 3 wire power open/ power close type.

The motor actuator is rated at 18lbs. of torque. Superior to low torque Spring type motors.

The Motor Actuator housing has a NEMA1 Rating.

Integrated End-Stop Adjustment allows for a percentage of Relief Air (Leakage) to be set when the damper is powered to closed and/or you may set a maximum open position as well.

Bright green and red LEDs Indicate damper open and closed position.

EWC Controls ND8X10

Arzel PAN-AB002 2-Zone Zone Control Panel

,


Arzel PAN-AB002

Outstanding Performance:
This damper was specifically designed with R8 insulation specification in mind to contribute to energy savings and help the system pass efficiency audits. Best of all, it helps eliminate hot and cold spots, the biggest cause of callbacks. The improved internal design creates a slower return that ensures a quiet operation.
Installation Made Easy
For fast, accurate installation with no callbacks, the TrueZONE Damper has you covered with a range of features that simplify installation in most applications:

Adjustable Range Stops  Easy to understand and set by utilizing a pushin lever. Theyre used to bleed air into the zones which helps lower pressure and reduce noise.

Push-In Terminals  The same easy wiring design used on TrueZONE Panels. No tools needed, has space for two wires.

Taping Flange  Lets you position insulation under it before sealing with foil tape.

Mechanical Position Indicator  Easy viewing through a clear window.

LED Indicator Lights  Red indicates the damper is closed and green indicates open (used in 3-wire applications)

Honeywell ZD10X12TZ

Duro Dyne 26068 Self Adhesive Insulation Hanger W/ Washer 1-1/4",
,

Duro Dyne 26068

Acme 91-08

The ND Damper is constructed using Heavy Duty 0.80 extruded aluminum.

Nylon Bearings for quiet operation.

Overlapping parallel blade design insures low leakage.

Designed to operate at static pressures up to 1.5 w.c.

The UL Listed Motor Actuator is a 24 vac 3 wire power open/ power close type.

The motor actuator is rated at 18lbs. of torque. Superior to low torque Spring type motors.

The Motor Actuator housing has a NEMA1 Rating.

Integrated End-Stop Adjustment allows for a percentage of Relief Air (Leakage) to be set when the damper is powered to closed and/or you may set a maximum open position as well.

Bright green and red LEDs Indicate damper open and closed position.

EWC Controls ND-16X10