Home  > INTERNATIONAL COMFORT PRODUCTS(x)
|◀ ◀ 745 - 756 of 1167 ▶ ▶|
View:

Heat Pump Condensing Unit High Efficiency 1.5 Ton

REFRIGERATION CIRCUIT
  • Copeland Scroll compressors on all models
  • Suction line accumulator factory installed
  • Biflow filterdrier included for field installation
  • Integrated solid state control with TimeTemperature Defrost
  • High and Low pressure switches
  • Copper tube / aluminum fin coil EASY TO INSTALL AND SERVICE
  • Easy Access service valves on all models
  • External high and low refrigerant service ports
  • Only two screws to access control panel
  • Factory charged with R410A refrigerant BUILT TO LAST
  • Bakedon powder coat finish over galvanized steel
  • Postpainted (black) coil fins
  • Coated, weatherresistant cabinet screws
  • Coated inlet grille with 3/8 (10mm) grille spacing for extra protection

    International Comfort Products N4H5S60CKAAA

    • Item#:
    NXH518GKP
    Manufacturer Item:
    NXH518GKP
    Manufacturer:
    INTERNATIONAL COMFORT PRODUCTS
     
    NXH5-ICP-Service_Misc
    NXH5-ICP_Broc
    NXH5-ICP_Install
    NXH5-ICP_Spec

    Uncased Vertical Coil kit 3 Ton Up-Flow/Down-Flow R454B 16-1/4" H x 15" W x 20-3/4" D

  • Uncased
  • Vertical
  • Up-Flow/Down-Flow
  • Coil Kit
  • R545B

    International Comfort Products NADA43601CK

    • Item#:
    NAVA53601CK
    Manufacturer Item:
    NAVA53601CK
    Manufacturer:
    INTERNATIONAL COMFORT PRODUCTS

    80% Standard NOX Gas Heating Furnace 33-1/3" H x 17-1/2" W x 29" D

  • 80% AFUE
  • Flame roll--out sensors standard
  • Category I venting
  • Blocked vent switch
  • Louvered door
  • 24 VAC and 115 VAC humidifier terminal
  • Electronic air cleaner termina
  • l
  • N80ESL -- Low NOx units are designed for California installations and meet 40 ng/J NOx emissions. Can be installed in air quality management districts with a 40 ng/J NOx emissions requirement.
  • Cabinet air leakage less than 2.0% at 1.0 in. W.C. and cabinet air leakage less than 1.4% at 0.5 in. W.C. when tested in accordance with ASHRAE standard 193
  • Adjustable heating blower OFF delay
  • Factory set blower ON delay
  • RPJ aluminized steel heat exchanger
  • High temperature limit control prevents overheating
  • Direct ignition with Silicon Nitride ignitor
  • One piece prepainted steel cabinet

    International Comfort Products N80ESN0701712A

    • Item#:
    N80ESN0701712A
    Manufacturer Item:
    N80ESN0701712A
    Manufacturer:
    INTERNATIONAL COMFORT PRODUCTS
     
    N80ESN-ICP-Care_Misc
    N80ESN-ICP_Install
    N80ESN0701712A_Spec

    80% Standard NOX Gas Heating Furnace 33-1/3" H x 24-1/2" W x 29" D

  • 80% AFUE
  • Flame roll--out sensors standard
  • Category I venting
  • Blocked vent switch
  • Louvered door
  • 24 VAC and 115 VAC humidifier terminal
  • Electronic air cleaner termina
  • l
  • N80ESL -- Low NOx units are designed for California installations and meet 40 ng/J NOx emissions. Can be installed in air quality management districts with a 40 ng/J NOx emissions requirement.
  • Cabinet air leakage less than 2.0% at 1.0 in. W.C. and cabinet air leakage less than 1.4% at 0.5 in. W.C. when tested in accordance with ASHRAE standard 193
  • Adjustable heating blower OFF delay
  • Factory set blower ON delay
  • RPJ aluminized steel heat exchanger
  • High temperature limit control prevents overheating
  • Direct ignition with Silicon Nitride ignitor
  • One piece prepainted steel cabinet

    International Comfort Products N80ESN0701716A

    • Item#:
    N80ESN1352420A
    Manufacturer Item:
    N80ESN1352420A
    Manufacturer:
    INTERNATIONAL COMFORT PRODUCTS
     
    N80ESN-ICP-Care_Misc
    N80ESN-ICP_Install
    N80ESN1352420A_Spec

    Air Conditioning Condensing Unit 1.5 Ton 13.4 SEER 2 Stage R454B Filter Drier Scroll Compressor

  • Efficiency 13.4 - 16.0 SEER2 / 11.0-13.5 EER2
  • Indoor air quality accessories available Comfort
  • System supports programmable or standard thermostat controls Reliability
  • Non-ozone depleting, low global warming potential R-454B refrigerant
  • Scroll compressor
  • Internal pressure relief valve
  • Internal thermal overload Filter drier Durability Protection Package:
  • Solid, durable sheet metal construction
  • Dense wire coil guard Applications
  • Long line up to 250 feet (76.20 m) total equivalent length, up to 200 feet (60.96 m) condenser above evaporator, or up to 80 ft. (24.4 m) evaporator above condenser (See Long Line Guide for more information.)
  • Low ambient cooling (down to 0°F / -18°C ) with approved low ambient accessory kits.

    International Comfort Products H5A8T60AKAWA

    • Item#:
    N5A4S18AKANA
    Manufacturer Item:
    N5A4S18AKANA
    Manufacturer:
    INTERNATIONAL COMFORT PRODUCTS
     
    N5A4S_SPEC

    96% Direct Vent 2-Pipe Gas Heating Furnace 35" H x 21" W x 29-1/2" D

  • Up to 97% AFUE in upflow/horizontal, up to 95% AFUE in downflow
  • Multi 18-speed, constant torque (MCT) ECM blower motor
  • Enhanced diagnostics with easy to read 3 digit display for faults and status
  • Supports single-stage cooling units
  • Insulated heat exchanger compartmen
    t
  • All sizes can be installed in air quality management districts with a 40 ng/J
  • NOx emissions requirement
  • Cabinet air leakage less than 2.0% at 1.0 in. w.c. and cabinet air leakage less than 1.4% at 0.5 in. w.c. when tested in accordance with ASHRAE standard 193
  • Approved for twinning applications (0601716, 0801716, 0802120, 1002120, 1202422, 1402422) with accessory (order separately)
  • Approved for manufactured housing/mobile home applications (0401410 through 1202422) with accessory (order separately)

    International Comfort Products N96MSN0802120A

    • Item#:
    N96MSN0802120A
    Manufacturer Item:
    N96MSN0802120A
    Manufacturer:
    INTERNATIONAL COMFORT PRODUCTS
     
    N96MSN-Care_Misc
    N96MSN_Install

    Heat Pump Condensing Performance Series 5 Ton

    Quiet performance
  • Single-stage compressor operation
  • Dual fuel capable with a compatible gas furnace and thermostat for energy-saving heating
  • Durably built to withstand bad weather and debris
  • Designed for corrosion resistance and lasting performance
  • Single-speed fan motor
  • System protecting high and low-pressure switches and filter drier
  • Durable, protective inlet grille panels allow easy coil cleaning
  • Baked-on powder coat finish over Gallonvanized steel
  • Compatible with humidity sensing thermostats
  • Suction line accumulator factory installed
  • Bi-flow filter-drier included for field installation
  • Integrated solid state control with time-temperature defrost
  • High and low pressure switches
  • Copper tube/aluminum fin coil
  • Easy access service valves
  • External high and low refrigerant service ports
  • Only two screws to access control panel
  • Post-painted (black) coil fins
  • Coated, weather-resistant cabinet screws
  • Coated inlet grille with 3/8" spacing for extra protection

    International Comfort Products N4H442GKP

    • Item#:
    N4H460GH
    Manufacturer Item:
    N4H460GHP
    Manufacturer:
    INTERNATIONAL COMFORT PRODUCTS
     
    N4H4-ICP-Wiring_Misc
    N4H4-ICP_Broc
    N4H4-ICP_Install

    Air Conditioning Condensing Unit 4 Ton 18 SEER 2 Stage 230/1 R454B

  • Efficiency 13.4 - 16.0 SEER2 / 11.0-13.5 EER2
  • Indoor air quality accessories available
  • System supports programmable or standard thermostat controls
  • Non-ozone depleting, low global warming potential R-454B refrigerant
  • Scroll compressor
  • Internal pressure relief valve
  • Internal thermal overload
  • Filter drier
  • Solid, durable sheet metal construction
  • Dense wire coil guard

    International Comfort Products N5A8T36AKAWA

    • Item#:
    N5A8T48AKAWA
    Manufacturer Item:
    N5A8T48AKAWA
    Manufacturer:
    INTERNATIONAL COMFORT PRODUCTS
     
    N5A8T48AKAWA_Spec

    Air Conditioning Condensing Unit 1-Stage 1.5 Ton 15 SEER

  • Efficiency 13.4 - 16.0 SEER2 / 11.0-13.5 EER2
  • Indoor air quality accessories available
  • System supports programmable or standard thermostat controls
  • Non-ozone depleting, low global warming potential R-454B refrigerant
  • Scroll compressor
  • Internal pressure relief valve
  • Internal thermal overload
  • Filter drier
  • Solid, durable sheet metal construction
  • Dense wire coil guard

    International Comfort Products N5A4S60AKANA

    • Item#:
    N5A5S18AKAWA
    Manufacturer Item:
    N5A5S18AKAWA
    Manufacturer:
    INTERNATIONAL COMFORT PRODUCTS
     
    N5A5S-Series_Spec

    80% Category I Venting Gas Heating Furnace 33-1/3" H x 17-1/2" W x 29" D

  • Multi 18-Speed, Constant Torque (MCT) ECM blower motor
  • Enhanced diagnostics with easy to read 3 digit display for faults and Status
  • 80% AFUE
  • Flame roll-out sensors standard
  • Category I venting
  • Blocked vent switch
  • Louvered door
  • 24 VAC humidifier terminal
  • Electronic air cleaner terminal
  • Select sizes approved for twinning, refer to accessory kit listing
  • N80MSL - Low NOx units are designed for California installations and can be installed in air quality management districts with a 40ng/J NOx emissions limit
  • Cabinet air leakage less than 2.0% at 1.0 in. w.c. and cabinet air leakage less than 1.4% at 0.5 in. w.c. when tested in accordance with ASHRAE standard 193



    International Comfort Products N80MSN0451714A

    • Item#:
    N80MSN0901714A
    Manufacturer Item:
    N80MSN0901714A
    Manufacturer:
    INTERNATIONAL COMFORT PRODUCTS
     
    N80MSN-ICP-Care_Misc
    N80MSN-ICP_Install

    Air Conditioning Condensing Unit 2 Ton 18 SEER 2 Stage 230/1 R454B

    Efficiency
  • 13.8 - 17.0 SEER2 / 11.2  14.5 EER2
  • Indoor air quality accessories available
  • Comfort
  • System supports programmable or standard thermostat controls
  • Reliability
  • Non-oz.one depleting, low global warming potential R-454B refrigerant
  • Scroll compressor
  • Internal pressure relief valve
  • Internal thermal overload
  • Filter drier
    Durability
  • Protection Package:
  • Solid, durable sheet metal construction
  • Dense wire coil guard
    • Item#:
    N5A8T24AKAWA
    Manufacturer Item:
    N5A8T24AKAWA
    Manufacturer:
    INTERNATIONAL COMFORT PRODUCTS
     
    N5A8T24AKAWA_Spec

    96% Direct Vent 2-Pipe Gas Heating Furnace 35" H x 17-1/2" W x 29-1/2" D

  • Up to 97% AFUE in upflow/horizontal, up to 95% AFUE in downflow
  • Multi 18-speed, constant torque (MCT) ECM blower motor
  • Enhanced diagnostics with easy to read 3 digit display for faults and status
  • Supports single-stage cooling units
  • Insulated heat exchanger compartmen
    t
  • All sizes can be installed in air quality management districts with a 40 ng/J
  • NOx emissions requirement
  • Cabinet air leakage less than 2.0% at 1.0 in. w.c. and cabinet air leakage less than 1.4% at 0.5 in. w.c. when tested in accordance with ASHRAE standard 193
  • Approved for twinning applications (0601716, 0801716, 0802120, 1002120, 1202422, 1402422) with accessory (order separately)
  • Approved for manufactured housing/mobile home applications (0401410 through 1202422) with accessory (order separately)

    International Comfort Products N96MSN0801716A

    • Item#:
    N96MSN0801716A
    Manufacturer Item:
    N96MSN0801716A
    Manufacturer:
    INTERNATIONAL COMFORT PRODUCTS
     
    N96MSN-Care_Misc
    N96MSN_Install
    |◀ ◀ 745 - 756 of 1167 ▶ ▶|
    View: