Home  > INTERNATIONAL COMFORT PRODUCTS(x)
|◀ 1 - 12 of 811 ▶|
View:
Honeywell Q348A1101 Universal Spark Pilot (Batwing Style)

INTERNATIONAL COMFORT PRODUCTS FXM4X3600AL

Item#:
FXM4X3600AL
Manufacturer Item:
FXM4X3600AL
Manufacturer:
INTERNATIONAL COMFORT PRODUCTS
ICP Fast Parts EHK10AKB Electric Heater 10 KW
    Item#:
    EHK10AKB
    Manufacturer Item:
    EHK10AKB
    Manufacturer:
    INTERNATIONAL COMFORT PRODUCTS
    Allanson 2603 Wayne E Mounting Plate

    ICP EHK210B

    Item#:
    EHK210B
    Manufacturer Item:
    EHK210B
    Manufacturer:
    INTERNATIONAL COMFORT PRODUCTS
    ICP END4X30L17A Sturdy Pre-Painted Steel Cabinet Upflow/Downflow (Vertical) Cased N Evaporator Coil with TXV Metering, 2.5 Ton, 30,000 BTU
    • Bolt-on TXV metering device factory installed on all models
    • (2) condensate drain connections
    • Removable front access panel
    • Hemmed flanges for safer handling
    • Foil faced insulation
    • Non-sweat cabinet even at eXtreme conditions
    • Cabinets meet or eXceed 2% air leakage codes
    • Up flow or down flow installation
    • Compact design, shorter than comparable a-coils
    • Aluminum hairpin
    • 5 years parts limited warranty
    Item#:
    END4X30L17
    Manufacturer Item:
    END4X30L17A
    Manufacturer:
    INTERNATIONAL COMFORT PRODUCTS
    80% Single Stage Heating Furnace
    • EASIER TO SELL
    • 80% AFUE
    • Flame rollout sensors standard
    • Category I venting
    • Blocked vent switch
    • Louvered door
    • 24 VAC and 115 VAC humidifier terminal
    • Electronic air cleaner terminal
    • Twinning furnaces of same heating and cooling sizes with approved kit
    • N8MSL California NOx approved
    • Certified to leak 2 percent or less of nominal air conditioning CFM delivered when pressurized to 1-inch Water Gauge with all present air inlets, air outlets, and condensate drain port(s) sealed
    • TOUGHER
    • PSC blower motor
    • Adjustable heating blower OFF delay
    • Factory set blower ON delay
    • RPJ aluminized steel heat exchanger
    • High temperature limit control prevents overheating
    • Direct ignition with Silicon Nitride ignitor
    • One piece prepainted steel cabinet
    • QUIETER
    • Inshot burners
    • EASIER TO INSTALL AND SERVICE
    • 33 1/3 (847mm) high, for ease of installation
    • Innovative knobs for easy door removal and secure attachment
    • Factory shipped for natural gas, with propane gas conversion kits available
    • Four position  upflow/downflow/horizontal (left/right) installation
    • Three position inducer elbow capability
    • Through the casing flue pipe for counterflow applications
    • Common venting with other Category I appliances
    • Masonry chimney adapter available
    • Self diagnostics
    • Slide out blower assembly
    Item#:
    N8MSN0701412
    Manufacturer Item:
    N8MSN0701412A
    Manufacturer:
    INTERNATIONAL COMFORT PRODUCTS

    ICP Fast A/C Parts OCA20

    Item#:
    OCA20
    Manufacturer Item:
    OCA20
    Manufacturer:
    INTERNATIONAL COMFORT PRODUCTS
    ICP Commercial PAJ436000KTP0B Rooftop Package Unit 36K BTU 3 Ton 230/1
    Item#:
    PAJ436000KTP0B
    Manufacturer Item:
    PAJ436000KTP0B
    Manufacturer:
    INTERNATIONAL COMFORT PRODUCTS
    Honeywell Q345A1321/U 1-Right Direct Tip Pilot Burner with Orifice for S86, S860, S8610, or S8670 in Intermittent Pilot Systems, Natural Gas
    • Non primary-aerated combination pilot burner and igniter
    • 0.78" compression fitting length
    • 0.01" BCR-18 orifice
    • Target tip style
    • K right direction of front tip
    • Includes special mounting bracket with screws to convert B bracket to A bracket
    Sid Harvey Item #:Q345A1321: Replaces Part #:'s : MHQ345A1321 | Q345AKBR |

    INTERNATIONAL COMFORT PRODUCTS FXM4X2400AL

    Item#:
    FXM4X2400AL
    Manufacturer Item:
    FXM4X2400AL
    Manufacturer:
    INTERNATIONAL COMFORT PRODUCTS
    ICP Fast Parts EHK15AKB Electric Heater 15 KW
      Item#:
      EHK15AKB
      Manufacturer Item:
      EHK15AKB
      Manufacturer:
      INTERNATIONAL COMFORT PRODUCTS
      Browning Super Gripbelt 3433000 Nylon Wrapped V-Belt, 33" L x 21/32" W x 7/16" T
      • Wrapped construction - provides smooth quiet operation, single fabric design allows greater flexibility, wrapped belts are more tolerant to slipping and misalignment than raw edge belts
      • Close belt tolerance - browning belts offer the"code 1" match belt system on all classical and 358 belts, allowing easy selection of just one match number for each belt size, this ensures tighter than RMA standards
      • High tensile cord - specially treated cords to provide strength and additional flex life while providing resistance to elongation for the belt
      • Static conductivity
      • 1 year warranty
      Sid Harvey Item #:B30-BELT: Replaces Part #:'s : A256-33 | Bx30 |

      International Comfort Products N80ESN0901714A

      Item#:
      N80ESN0901714A
      Manufacturer Item:
      N80ESN0901714A
      Manufacturer:
      INTERNATIONAL COMFORT PRODUCTS
      Quiet performance
      • Single-stage compressor operation
      • Dual fuel capable with a compatible gas furnace and thermostat for energy-saving heating
      • Durably built to withstand bad weather and debris
      • Designed for corrosion resistance and lasting performance
      • Single-speed fan motor
      • System protecting high and low-pressure switches and filter drier
      • Durable, protective inlet grille panels allow easy coil cleaning
      • Baked-on powder coat finish over Galvanized steel
      • Compatible with humidity sensing thermostats
      • Suction line accumulator factory installed
      • Bi-flow filter-drier included for field installation
      • Integrated solid state control with time-temperature defrost
      • High and low pressure switches
      • Copper tube/aluminum fin coil
      • Easy access service valves
      • External high and low refrigerant service ports
      • Only two screws to access control panel
      • Post-painted (black) coil fins
      • Coated, weather-resistant cabinet screws
      • Coated inlet grille with 3/8" spacing for extra protection
      Item#:
      N4H424GKG
      Manufacturer Item:
      N4H424GKG
      Manufacturer:
      INTERNATIONAL COMFORT PRODUCTS
      No Heat Kit for MV Series Blower Cabinet
      Item#:
      EHIA00KN10
      Manufacturer Item:
      EHIA00KN10
      Manufacturer:
      INTERNATIONAL COMFORT PRODUCTS
      |◀ 1 - 12 of 811 ▶|
      View: