Crown Boiler Parts 11-500 Door Refectory

crown boiler parts 11-500

Crown Boiler 233001 Inducer Blower Kit, 120 VAC

,

Crown Boiler Inducer Motor 233001

,

233001

Crown Motors 14-000 Fan Motor Assembly 3000 RPM 120 VAC PH XE F (Crown),

14-000

,

14-000

Crown Boiler Parts 3505065 Ignition Module

,



3505065

,


3505065

Crown Boiler Parts 35-1030C Ignition Wire 30"

Crown Boiler Parts 35-1030C

Crown Boiler Parts 233031 Ignitor Kit

crown boiler parts 233031

Crown Boiler Mega-Stor is the first indirect water heater to have its performance independently certified to specifications by the hydronics institute. This independent testing will assure you of accurate ratings. Mega-Stor is indirectly heated for efficiency. The boiler that heats your home or building provides more energy, while consuming fuel more efficiently, than direct-fired domestic water heaters. So Mega-Stor saves on fuel costs by using hot water from your boiler to heat water for your showers.

• The Mega-Stor is a stainless-steel indirect water heater which provides abundant domestic hot water utilizing energy provided by your boiler
• With a stainless steel, smooth surface coil that transfers heat throughout the tank, the Mega-Stor is capable of recovery rates well in excess of a typical gas, electric or oil water heater
• The 2" thick layer of polystyrene foam insulation keeps the water in your Mega-Stor hot for hours during stand-by periods

Dunkirk Heating Parts 411-54-052 Intermediate Boiler Section for Dunkirk D248, Pennco 41J, Utica JD Cast Iron Boilers

• ,
  
  

  411-54-052

  ,
  

  411-54-052

Crown Boiler Parts 960124 Limit Switch

,



960124

,


960124

Crown Boiler Parts 233022 BOARD Main Circuit Board Kit 120 VAC 60 Hz

233022 BOARD

Crown Boiler BSI-103-ENP Natural Gas Cast Iron Hot Steam Packaged Boiler,

BSI-103-ENP

,

BSI-103-ENP

Crown Boiler BSI-172-ENP Natural Gas Cast Iron Hot Steam Packaged Boiler Circulator/Ignition and Low Water Cut-Off
The Bermuda series (BSI) residential/light commercial, cast iron, steam boiler is a fully-packaged, installer-ready product. The integral draft diverter provides a low profile design allowing the boiler to be installed in areas requiring a low clearance. This atmospheric, gas-fired boiler is for use with a conventional chimney. The Bermuda series also comes standard with a probe-type low water cut-off safety control. The Bermuda series is packaged with the option of either natural or LP gas as well an electronic ignition system.

• The heat exchangers are built with steel push nipples below the water line where superior strength and resistance to expansion and contraction is important
• Cast iron push nipples above the water line are larger than often found on similar units to provide optimum steam quality
• Built-in draft diverter fits in low spaces
• Automatic vent damper included for models BSI069 through BSI276
• Attractive, rugged jacket
• Fully assembled or available as knock-down package
• Designed for installation on combustible floors
• Probe low water cut-off standard, option of float low water cut-off
• Glass water level gauge set
• Redundant gas valve
• Roll-out switch, blocked vent switch
• 6-section

,

BSI-172-ENP