• Interrupted duty ignition
• Recycle on flame failure
• Serviceman reset protection (latch-up after 3-consecutive lockouts)
• Diagnostic LED
• Valve delay on/motor delay off (pre/post-purge)
• 15 sec trial for ignition (TFI) other timings available
• 1.3 sec flame failure response time (FFRT)
• Alarm contacts
• Thermostat/aquastat compatible
• SMC (safety monitoring circuit) technology

Carlin Parts R77-44

Carlin Parts R77-43

• Interrupted duty ignition for high efficiency
• SMC technology for safety monitoring
• LED indicators, alarm contacts and pump prime for economic as well as efficient performance
• Serviceman reset protection ( latch-up after three consecutive lockouts)
• 15 sec trial for ignition (TFI) other timings available
• It offers recycle on flame failure and 1.3 sec flame failure response time
• Oil primary control has a input voltage rating of 120 VAC, input frequency rating of 60 Hz and input power rating of 9 VA
• It has a temperature rating of 32 - 140 deg F, resistive rating of 1500 ohm and safety switch timing of 15 sec
• Primary control offers serviceman reset protection and valve delay on/motor delay off feature
• It has a motor load of 10 FLA/60 LRA, ignitor load of 120 VAC at 60 Hz and valve load of 120 VAC at 60 Hz
• 500 VA motor load
• 24 VAC/VDC, 2 amp alarm contacts
• Flame signal test jack

Carlin Parts R77-41

• Interrupted duty ignition
• Recycle on flame failure
• Serviceman reset protection (latch-up after 3-consecutive lockouts)
• Diagnostic LED
• 15 sec trial for ignition (TFI) other timings available
• 1.3 sec flame failure response time (FFRT)
• Alarm contacts
• Thermostat/aquastat compatible
• SMC (safety monitoring circuit) technology

Carlin Parts R77-40

Carlin Parts SVC10FF

Carlin Parts 23259S

Carlin Parts 23135S

Carlin Parts 22889

Carlin Parts 234-4

Carlin Motors 27557S

• Thermal overload protection
• Capacitor start/induction run design
• Continuous duty

Carlin Motors 27730S