Home  > WAYNE COMBUSTION SYSTEMS(x)
View:
The P265F BB-E boiler burner features Wayne's new electrical enclosure design and muli-try ignition. Similar to the standard P265F BB, it's exclusively designed for conversion of boilers from oil to gas operation. This model utilizes a stainless steel air tube and stainless steel air tube end focusing ring to provide a tighter, shorter flame pattern, The P265F BB yields a high efficiency conversion, low emissions and is extremely simple to service. Maximum 6-3/8" usable insertion.
  • 4" diameter x 7-3/8" length air tube
  • 0.6 - 0.9 sq-Inch/1000 BTU/hr floor area
  • Modulation and on or off availability
  • 24 VAC gas valve
Item#:
P265FBB-E
Manufacturer Item:
64488
Manufacturer:
WAYNE COMBUSTION SYSTEMS
Thermo Dynamics Boilers 337350 Replacement Soft Chamber Only for S Series Boilers
Item#:
337350
Manufacturer Item:
337350
Manufacturer:
WAYNE COMBUSTION SYSTEMS
Thermo Dynamics Boilers 337410 Chamber Liner For HT Series Boilers
Item#:
337410
Manufacturer Item:
337410
Manufacturer:
WAYNE COMBUSTION SYSTEMS
Honeywell S89F1098 Direct Spark Ignition Control Module, 24 VAC at 60 Hz, 2 amp
  • Controls ignition sequence and gas control operation in direct spark ignition systems
  • Control separate 120 VAC spark generator that provides high voltage potential for main burner ignition
  • Lockout after 1-trial for ignition if main burner fails to ignite
  • Reset from thermostat after lockout
  • Use separate electrodes for spark ignition and flame sensing
  • Use any 24 VAC combination gas control designed for direct spark applications and rated at 2 amp or less
  • 2 sec at 2.5 micro-amp flame failure response time
  • 30 sec pre-purge
  • 1-trial for main burner ignition (then shut down and lockout) ignition sequence
  • VR8205, VR8305 typical gas control
  • Natural or LP type of gas
  • 2-rod flame sense
  • External (120 VAC powered) high voltage spark generator ignition source
  • (1) ignition trials to lockout
  • 4 sec lockout timing and ignition trial time
  • 0.8 sec maximum flame failure re-ignition time
  • Provide electronic control of direct spark ignition systems, with external spark transformers, used on gas-fired furnaces, boilers, conversion burners and other heating appliances
Item#:
S89F1098
Manufacturer Item:
62759-002
Manufacturer:
WAYNE COMBUSTION SYSTEMS
Wayne Combustion Systems 14157 Air Cone for EHAS Series Oil Burners, #1A
Sid Harvey Item #:14157: Replaces Part #:'s : SIDS14157
Item#:
14157
Manufacturer Item:
14157
Manufacturer:
WAYNE COMBUSTION SYSTEMS
Wayne Combustion Systems 62261 Electrode Flame Sensor Assembly for Gas Burner
Item#:
62261
Manufacturer:
WAYNE COMBUSTION SYSTEMS
Thermo Dynamics Boilers 337817 Square Target Wall Insulation For LM Series Direct Vent Oil Fired Hot Water Boilers, 1/2 Inch T
Item#:
337817
Manufacturer Item:
337817
Manufacturer:
WAYNE COMBUSTION SYSTEMS
Wayne Combustion Systems 100950-001 Tune-Up Kit for Blue Angel Plus HS Burners
Item#:
100950-001
Manufacturer Item:
100950-001
Manufacturer:
WAYNE COMBUSTION SYSTEMS
Item#:
101295-SERM
Manufacturer Item:
101295-SERM
Manufacturer:
WAYNE COMBUSTION SYSTEMS
Item#:
63263-005
Manufacturer Item:
63263-005
Manufacturer:
WAYNE COMBUSTION SYSTEMS
Wayne Combustion Systems 60533 Orifice for Blank P250/P265 Style Burner
Item#:
60533
Manufacturer Item:
60533
Manufacturer:
WAYNE COMBUSTION SYSTEMS
Wayne Combustion Systems 20627 Split Phase Motor for HSG200, HSG400 Gas
Item#:
20627
Manufacturer Item:
20627
Manufacturer:
WAYNE COMBUSTION SYSTEMS
View: