Home  > NORTEK GLOBAL-(PHILCO PLUS)(x)
View:
Nortek KG7TC 100D-35C 2-Stage Condensing Fixed Speed ECM Gas Furnace, 95.1% AFUE, 115 VAC, 100000 BTU/hr
  • 100% fired and tested - all units and each component are tested on the manufacturing line
  • Best packaging in the industry - unique corner post design assures product will arrive to the homeowner dent free
  • 30 sec blower delay at start-up assures a warm duct temperature at furnace start-up, adjustable blower off settings (60, 90, 120 and 180 sec)
  • 30 sec post purge increases life of heat exchanger
  • Hot surface igniter - innovative application of a silicon nitride type igniter, utilizes proven Smartlite technology
  • Color-coded wire harness designed to fit the components, all with quick-connect fittings for ease of service and replacement
  • Flexible category IV venting system may be vertically or horizontally vented using either a 1 or 2-pipe system for maximum flexibility in installation
  • High static blowers - all models equipped with high static blowers
  • Lowboy height easy to apply in low ceiling applications, works well with taller high seer coils, easier to handle and install
  • Tubular primary heat exchanger - Heavy-gauge aluminized steel heat exchanger and stainless steel secondary heat exchanger assures a long life
  • 90 sec fixed cooling cycle blower-off delay (TDR) - increases cooling performance when matched with a Nordyne coil
  • Variable speed blower kit - upgradable to full variable speed with kit
  • LP convertible - simple burner orifice and regulator spring change for ease of convertibility
  • Diagnostic lights for easy troubleshooting without counting flashes - dedicated light for flame signal strength and 2-lights in combination to indicate all other fault codes with easy to recognize states without counting flashes
  • Incorporates integrated control board with connections for electronic air cleaner, humidifier and twinning
  • 2-piece door design - enhances furnace appearance and uses captured screws to prevent losing door screws
  • 10 years parts limited warranty
  • 90% AFUE low NOx
Item#:
KG7TC 100D-35C
Manufacturer Item:
922326K
Manufacturer:
NORTEK GLOBAL-(PHILCO PLUS)
Nortek GB5BM-036K-B Polyester Urethane Galvanized Steel Residential System Air Handler with Piston Metering, 36000 BTU/hr, 3 ton, 20 kw, 208 - 230 VAC
  • 10 years all parts warranty
  • Durable, attractive cabinet - designed using galvanized steel, the door is also galvanized steel, with a polyester urethane finish, the 950 hr salt spray finish resists corrosion 50% better than comparable units, the plastic drain pan is corrosion-resistant
  • Multi-speed gives flexibility of installation
  • Ease-of-service - plug-in wire connections and built-in filter rack makes the air handler easy to service
  • Circuit board - incorporating blower time delay relay, low VAC age terminal strip and heat-strip sequencing
  • Air handler control board - controls time-sequencing of heat stages with field-selectable sequence timing
  • Breaker accessibility - breaker accessible from front of unit when heater is applied
  • No fasteners on sides or back - smooth surfaces for ease of installation
  • Design series
  • PSC, 3-speed motor
  • 10 x 8" blower
  • 12-7/8 x 18-1/4" supply air outlet
Item#:
GB5BM-036K-B
Manufacturer Item:
904243GD
Manufacturer:
NORTEK GLOBAL-(PHILCO PLUS)
Nortek B5BM-X48K-C Polyester Urethane Galvanized Steel Residential System Air Handler with TXV Metering, 48000 BTU/hr, 4 ton, 30 kw, 208 - 230 VAC
  • 10 years all parts warranty
  • Durable, attractive cabinet - designed using galvanized steel, the door is also galvanized steel, with a polyester urethane finish, the 950 hr salt spray finish resists corrosion 50% better than comparable units, the plastic drain pan is corrosion-resistant
  • Multi-speed gives flexibility of installation
  • Ease-of-service - plug-in wire connections and built-in filter rack makes the air handler easy to service
  • Circuit board - incorporating blower time delay relay, low VAC age terminal strip and heat-strip sequencing
  • Air handler control board - controls time-sequencing of heat stages with field-selectable sequence timing
  • Breaker accessibility - breaker accessible from front of unit when heater is applied
  • No fasteners on sides or back - smooth surfaces for ease of installation
  • 1" insulation with an R-value of 4.2 contributes to quiet operation and prevents cabinet sweating in difficult applications
  • Design series
  • PSC, 3-speed motor
  • 10 x 10" blower
  • 12-7/8 x 21" supply air outlet
Item#:
B5BM-X48K-C
Manufacturer Item:
904309D
Manufacturer:
NORTEK GLOBAL-(PHILCO PLUS)
Nortek C6BA-F42U-B Vertical Indoor Uncased A Flexible Evaporator Coil, 3.5 ton, 42000 BTU/hr
Item#:
920668A
Manufacturer Item:
920668A
Manufacturer:
NORTEK GLOBAL-(PHILCO PLUS)
Nortek iHybrid DF6SE-X36K096C Galvanized Steel Square Duct Dual Fuel Package Unit, 36000 BTU/hr Cooling, 96000 BTU/hr Heating, 2 - 5 ton, 208 - 230 VAC
  • These dual fuel package units are high efficiency self contained heat pump units that can be installed on the roof or on a slab
  • The convertible unit design makes installations simple in all applications
  • Heavy gauge full perimeter base rails - facilitates forklift handling and curb mounting
  • Compact footprint/low profile - easy to handle and transport
  • Copeland Ultra-Tech 2-stage heat/cool scroll compressor
  • Convertible air delivery - horizontal or downflow to accommodate rooftop or horizontal applications
  • Galvanized steel cabinet with polyurethane finish provides 950 hr salt spray protection to resist corrosion
  • Plastic coated coil guard and mesh hail guard will never rust and protect the coil from being damaged by balls, lawnmowers, hail etc
  • Externally accessible service ports- quick access to refrigerant system without disrupting operation
  • High/low pressure switches added compressor protection
  • Access to controls and major components easy in and out service
  • Corrosion resistant drain pan quickly drains away evaporator condensate
  • Proven industry standard components easier service and availability
  • Smaller panels, great fit and finish - total seal well designed, quality construction, drip edge on top panels whisks away rainwater, embossed bottom pan keeps blower component compartment dry
  • Thermostatic expansion valve(TXV)- factory installed externally equalized thermostatic expansion valve provides precise refrigerant control under varying load conditions
  • R-410A refrigerant - environmentally friendly
  • ECM variable speed motor - advanced technology allows the motor to automatically adjust to different static loads, the variable speed motor allows for extra quiet operation and improved air quality
  • Quiet operation low vibration, 20 Inch swept wing fan blade combined with custom venturi condenser fan
  • Compressor sound blanket
  • 4-stage heat/2-stage cool with variable speed blower
Item#:
DF6SE-X36K096C
Manufacturer Item:
920988
Manufacturer:
NORTEK GLOBAL-(PHILCO PLUS)
Nortek 904617 Side Wall Vent Kit for GUH95T, GUH95A, GUH92A, GDD95A,
Item#:
904617
Manufacturer Item:
904617
Manufacturer:
NORTEK GLOBAL-(PHILCO PLUS)
Nortek 904347 Side Wall Vent Kit for 3 Inch Condensing Gas Furnace Vent
Item#:
904347
Manufacturer Item:
904347
Manufacturer:
NORTEK GLOBAL-(PHILCO PLUS)
Nortek C6BA-X35U-A Vertical Uncased A Indoor Evaporator Coil with TXV Metering, 3 ton, 35,000 BTU/hr, 14-1/4 " W
Item#:
C6BA-X35U-A
Manufacturer Item:
920037
Manufacturer:
NORTEK GLOBAL-(PHILCO PLUS)
View: