Sid Harvey C308 Universal Well Adapter

• Eliminates the need for draining when replacing obsolete hot water controls
• Adapts modern control to old well with inside diameter of 1/2, 3/4, 11/16 Inch, instructions included

Sid Harvey Item #:C308: Replaces Part #:'s : 2C894,

,

Sid Harvey C308

Honeywell C7250A1001 Sensor MA 20K,
,

Honeywell C7250A1001

Resideo C554A1463 Cadmium-Sulfide Flame Detector,
,

Honeywell C554A1463

Mcdonnell & Miller FS254 Brass and Aluminum Base General Purpose Liquid Flow Switch, 120/240 VAC, 50/60 Hz, SPDT

• Universal design serves the widest variety of applications
• 2 electrical knock-outs allows connection from either end
• Sensitivity adjusting screw makes flow adjustment easy
• Single pole, double throw snap switch
• EPDM o-ring sealed
• 1, 2, 3 and 6" (4) stainless steel paddles included
• Brass wetted body, paddle arm, pivot pin, stainless steel paddles, aluminum housing base and cover
• 125 VA at 120/240 VAC pilot duty

,

McDonnell & Miller FS254

Mcdonnell & Miller 120611 General Purpose Liquid Flow Switch, SPDT, 160 psi, 120/240 VAC

• Universal design serves the widest variety of applications
• Replacement for common flow switches from Johnson/Penn, Potter/Taco, Watts, Hydrolevel and other manufacturers
• Sensitivity adjusting screw makes flow adjustment easy
• EPDM o-ring seal
• Four stainless steel paddles included 1, 2, 3 and 6"
• 27 gpm maximum flow rate without paddle damage
• 5.8 - 17.6 gpm with flow, 5.1 - 6.53 gpm no flow mode of operation

,
,

McDonnell & Miller FS251

Sealed Unit Parts JV1 Jones Valve,

Sealed Unit Parts JV1

Honeywell M847D-VENT/U 2-Position Replacement Spring Return Actuator, 24 volt, Power Open/Spring Closed Motor

• The M847D is a two position, 24 VAC spring return actuators designed to operate ARD, EARD and ZD zone dampers
• Low voltage, spring return damper actuators
• Equipped with anti-rotation and drive shaft extensions for direct mounting to 7 or 16" diameter coupling style dampers
• Adjustable range stops

,
,

Honeywell L408J1009

Tjernlund MAC1E is used in conjunction with the UC1 universal control to interlock one additional 24 VAC, 115 VAC or millivolt controlled appliance. Millivolt appliances require a WHKE kit. Powered by and communicates with the UC1 through a factory wired whip. It activates the inducer/blower through its connections to the UC1, and in turn relies on the UC1 fan prover safety circuit (P1 and P2) to allow its interlocked appliance to operate. Any pre/post-purge settings on the UC1 will be defaulted to the MAC1E.

• The MAC1E puts an end to difficult and costly job site wiring nightmares
• Circuit board housed in oversized 18 ga electrical box with multiple knock outs for easy wiring connections

Sid Harvey Item #:MAC1E: Replaces Part #:'s : 21778,
,

Tjernlund MAC1E

Robertshaw Controls MT-512E-2HP Digital Control 115/230 VAC

Robertshaw MT-512E-2HP

Packard PFS401 Flame Sensor,
,

Packard PFS401

Spirotherm PJR000HA Head Assembly Replacement,

,

Spirotherm PJR000HA

Sid Harvey P15 2-Hole Stepped Down Pump Foot Mounting Flange for Pumps with Barrels of 2-1/8 Inch Nominal Dia.

• Opposing set screws for firm and secure lock-up
• Threaded for 1/2-13 bolt

,
,

Sid Harvey P15