|◀ 2365 - 2376 of 6114 ▶|
View:
Williamsom-Thermoflo Parts RB-PMP/LP-098 Oil Burner Williamson
    ,

    Williamson -Thermoflo Parts RB-PMP/LP-098

Item#:
RB-PMP/LP-098
Manufacturer Item:
RB-PMP/LB-098
Manufacturer:
RIELLO CORP OF AMERICA
Fieldpiece Instruments OIL32 Vacuum Pump Oil Quart,
,

Fieldpiece Instruments OIL32

Item#:
OIL32
Manufacturer Item:
OIL32
Manufacturer:
FIELDPIECE INSTRUMENTS,INC
Flow Rate
  • Atomizing nozzles are available in a wide range of flow rates, all but eliminating the need for specially calibrated nozzles. Between 1.00 GPH and 2.00 GPH, for example, seven different flow rates are available. Generally, with hot water and warm air heat, the smallest firing rate that will adequately heat the house on the coldest day is the proper size to use and the most economical. Short on-cycles result in low efficiency. Another guideline is to select the flow rate that provides a reasonable stack temperature regardless of the connected load. (According to the New England Fuel Institute, aim for a stack temperature of 400°F or lower on matched packaged units or 500°F or lower on conversion burners.) If the boiler or furnace is undersized for the load, it may be necessary to fire for the load and ignore the efficiency
    Spray Angle
  • Spray angles are available from 30° through 90° in most nozzle sizes to meet the requirements of a wide variety of burner air patterns and combustion chambers. Usually it is desirable to fit the spray angle to the air pattern of the burner. In todays flame retention burner, it is possible to fire more than one spray angle with good results. Generally, round or square combustion chambers should be fired with 70° to 90° nozzles. Long, narrow chambers usually require 30° to 60° spray angles.
  • Burner Air Patterns
  • Burner air patterns are much like nozzle spray patterns in that they fall into the same general classifications, either hollow or solid. As you would expect, a burner with a hollow air pattern generally requires a hollow cone fuel nozzle. A burner with a solid air pattern will give highest efficiency with a solid cone nozzle, but the flame will probably be longer

    Bosch 7747028944

  • Item#:
    7747028944
    Manufacturer Item:
    7-747-028-944
    Manufacturer:
    BOSCH THERMOTECHNOLOGY CORP
    Each tank needs to be installed with an oil gauge. The gauge base is treaded 2" NPT with a rubber"O-Ring" for sealing. It needs to be mounted on 1 of the plastic adapters provided with the tank with no need for pipe dope or Teflon tape on the threads. Must be hand tightened only. String and float must be released slowly during installation to prevent damage to the gearing or loosening the line off the reel. Housing design and color may differ depending on tank model.,

    ,

    Roth 2335003723

    Item#:
    2335003723
    Manufacturer Item:
    2335003832
    Manufacturer:
    OIL TANKS
    Carlin Parts 82792S Electrode Set for EZ1, 100CRD and 201CRD Burners

    Carlin Parts 82792S

    Item#:
    82792S
    Manufacturer Item:
    82792S
    Manufacturer:
    CARLIN COMBUSTION TECHNOLOGY
    Carlin Parts 82784S Electrode Set for EZ1, 99FRD, 102CRD Burners

    Carlin Parts 82784S

    Item#:
    82784S
    Manufacturer Item:
    82784S
    Manufacturer:
    CARLIN COMBUSTION TECHNOLOGY
    Carlin Parts 82776S Electrode Set for EZ1, 102CRD, 201CRD, 301CRD Carlin Oil Burners

    Carlin Parts 82776S

    Item#:
    82776S
    Manufacturer Item:
    82776S
    Manufacturer:
    CARLIN COMBUSTION TECHNOLOGY
    Great Lakes Copper 31385-PROTEC Protec Plus Soft Copper Roll 3/8" x 50' Red

    Great Lakes Copper 31385-PROTEC

    Item#:
    31385-PROTEC
    Manufacturer Item:
    31385
    Manufacturer:
    COPPER PIPE & TUBING
    Sid Harvey Remanufactured A39-321R Oil Burner Motor Beckett 3450 RPM 115 VAC PSC REMANUFACTURED,
    ,

    Sid Harvey Remanufactured A39-321R

    Item#:
    A39-321R
    Manufacturer Item:
    MTROB1-REMAN
    Manufacturer:
    SID HARVEY REMANUFACTURED
    Bacharach N28-11 Oil Burner Combustion Test Kit Fyrite Classic Combustion Analyzers
    Bacharach combustion testing kits continue to offer you the most economical means of testing for oil burner efficiency during installation or servicing. Each kit is designed with the service technician in mind and contains the instruments listed in the ordering chart.
    • The fyrite carbon dioxide indicator measures the percent CO2 in a flue gas sample
    • True spot smoke tester and oil burner smoke scale with the true spot smoke tester and smoke scale, you can get a accurate indication of smoke content in flue gas
    • Fire efficiency finder/stack loss slide rule is a quick and easy way of determining combustion efficiency and stack loss from the results of the CO2 and stack temperature tests
    • High stack temperatures are cause for special concern and may indicate a serious condition
    • The intensity of draft determines the rate at which combustion gases pass through the boiler or furnace
    • With the MZF draft gauge, you can determine if draft is excessive or insufficient
    Sid Harvey Item #:N28-11: Replaces Part #:'s : 1F170,
    ,



    Bacharach N28-11


    Bacharach N28-11

    Item#:
    N28-11
    Manufacturer Item:
    10-5022
    Manufacturer:
    MSA SAFETY SALES, LLC
    Beckett Parts Parts 7610B0001U AquaSmart Boiler Temperature Control (120V), Gas W/ Temp. ONLY Sensor (24V Burner Circuit)

    Beckett Parts 7610B0001U

    Item#:
    7610B0001U
    Manufacturer Item:
    7610B0001U
    Manufacturer:
    RW BECKETT CORP
    ECR International Heating Parts 14615532 Gas Burner

    ECR International Heating Parts 14615532

    Item#:
    14615532
    Manufacturer Item:
    146-15-532
    Manufacturer:
    ECR INTERNATIONAL, INC.
    |◀ 2365 - 2376 of 6114 ▶|
    View: