S2K Commerce - Products Dropdown
S2K Commerce - Shopping Cart
S2K Commerce - Order Entry
Nortek Global Heating Parts 104360001 Roof Jack Extension CMF
Item#:
104360001
Manufacturer Item:
104360001
Manufacturer:
NORTEK GLOBAL (INTERTHERM)
Bell & Gossett 113001 7 Brass Automatic Air Vent, 1/8", FNPT
- Designed to vent the accumulation of troublesome air wherever it can be trapped
Item#:
113001
Manufacturer Item:
113001
Manufacturer:
BELL & GOSSETT ITT
Honeywell 10700108 Bare Copper Mini Split THHN Tray Cable, 14/4 AWG, Stranded, 250 feet, Black
- Direct burial, sunlight resistant
- Once the cable enters the structure, it must be contained in conduit
- Cable must be installed in conduit indoors or in-wall,
Item#:
10700108
Manufacturer Item:
10700108
Manufacturer:
GENESIS CABLE
International Comfort Products Fast Parts 1178001 Circuit Board for WPA3, WPH3 (2 - 4 Ton, 5 Ton, R410A) Package Units
Item#:
1178001
Manufacturer Item:
1178001
Manufacturer:
ICP FAST PARTS
Hoffman WC-8-20B Simplex Condensate Pump, 1/3 HP, 115/230 VAC , 12 gpm
- Condensate pumps are designed to collect condensate and return it to the boiler
- As condensate flows to the receiver tank, it fills with water, the float switch assembly then rises and signals the motor on the pump to start and begin pumping the condensate
- When the float drops with the lower water level and breaks the contact on the switch, the pump will shut off
- This Watchman condensate unit features a corrosion-resistant cast iron receiver with low inlet heights for ease of installation
- The centrifuGallon pump is close-coupled and vertically-mounted with a bronze impeller
- 8000 equivalent direct radiation
Item#:
180001
Manufacturer Item:
180001
Manufacturer:
R.D. BITZER CO INC
Hoffman Specialty 180013 Seal Kit Watchman A & B Design Units
Item#:
180013
Manufacturer Item:
180013
Manufacturer:
BELL & GOSSETT ITT
US Motors 1779P 1-PH Permanent Split Capacitor Condenser Fan Motor, 1/15 HP, 230 VAC, 1300/1500 RPM
- Attaches by 4-machine screws shaft end
- (2) 30" lead length
- Automatic thermal overload protection
- Designed for use with 370 VAC capacitors
Item#:
1779P
Manufacturer Item:
OTC6001
Manufacturer:
NIDEC MOTOR CORPORATION
Bramec Corporation and is a major distributor in the Electrical, Plumbing, Hardware and HVAC/R industry
19001BR Liquid Tight Straight Connector 3/4"
Hart & Cooley 2000153 Smart filter seal is a durable yet flexible high-strength film designed to fit tightly over the air filter slot on the return air plenum and prevent air from bypassing the filter and thus improve indoor air quality. Magnets surrounding the perimeter hold it tight against the plenum to prevent air leakage. It can be easily removed to change out dirty air filters and replaced again. The 2009 edition of the International Energy Conservation Code (IECC), section 403.2.2 states,"sealing all ducts, air handlers, filter boxes, and building cavities used as ducts shall be sealed." The smart filter seal fulfills that requirement. Both the U.S. Department of energy and energy star recommend sealing the furnace slot.
Crown Engineering Chem-Flush - 1 opens fuel lines that are plugged due to ice and sludge build-up. Chem flush - 1 can also be use to clean the filter pump and nozzle strainer when used as a full maintenance or tune-up product. Therefore, greatly reducing the number of service calls due to plugged fuel lines during the heating season.
Item#:
2001CF
Manufacturer Item:
2001CF
Manufacturer:
CROWN ENGINEERING CORP
Lennox 20054001 Inducer Blower Assembly, 115 volt, 3450 RPM
Item#:
20054001
Manufacturer Item:
20054001
Manufacturer:
REGAL BELOIT AMERICA INC- FDC
Skuttle 2001 Thermoplastic High Capacity Flow-Through By-Pass Humidifier, 18 Gallon/day, 24 VAC, 15652 - 34286 cu-feet
- Compact width fits plenums as narrow as 14"
- Low profile makes units ideal where space is limited
- Shut-off damper reduces airflow in summer allowing air conditioner to run more efficiently and economically
- Reversible side panels permit left or right side bypass installation
- Superior patented wicking and water distribution system accommodates non-level plenums
- Frameless evaporator pad avoids breakage common to brands with plastic frames
- Internal solenoid resists damage from bumping
- Stainless steel orifice won't break and cleans easily
- Thermoplastic cabinet resists rust, corrosion and warpage
- Barbed drain fitting prevents hose from slipping
- Energy-efficient technology uses minimal water and electricity
- 6" diameter bypass opening
- 1/4" outside diameter copper water supply tubing
- 1/2" inside diameter water drain tubing
- 9-7/8" width x 16-5/8" height x 1-9/16" depth evaporator pad
- 6.26 lb/hr at 120 deg F
- Upflow, downflow, horizontal installations
- Extended 5 years limited warranty