|◀ 1 - 12 of 781 ▶|
View:
Sid Harvey F2-17 AO Sludge Dispersant and De-Icer 8 oz One-Shot Bottle
Item#:
F2-17 AO
Manufacturer Item:
F2-17AO
Manufacturer:
SID HARVEY INDUSTRIES INC.
FlowPro -100° anti-freeze solution protects by lowering freeze point. Below the freeze point, ice crystals begin forming and the remaining solution becomes more concentrated. As it concentrates, FlowPro consistency turns into a flowing slush. Unlike water, FlowPro actually contracts as it gets colder. This slushy formula is now capable of flowing into and filling available expansion volume in the system.
  • Non-toxic, non-corrosive formula
  • Chemically balanced inhibited solution engineered to give worry-free protection
  • Expansion point to -100 deg F
  • Systems will flow to 61 deg F
Sid Harvey Item #:18-446: Replaces Part #:'s : 27623
Item#:
18-446
Manufacturer Item:
18-446
Manufacturer:
SID HARVEY INDUSTRIES INC.
Nu-Calgon 4299-T8 Pump Protector, 10 oz Spray Can, Colorless Foam-in shut down corrosion protection for all types of pumps any pump that is shut down and drained part of the time should be safeguarded with aerosol pump protector. Pumps used in cooling towers, swimming pools and vacation homes, auxiliary pumps, marine and industrial pumps can develop corrosion deposits on the impeller and other close-tolerance areas during shut down, causing the pump to bind. Aerosol pump protector prevents this corrosion and lubricates the pump so that it starts right up every time! pump protector is water soluble and will not cause any foaming problem when the pump is started. If the pump is used for drinking water, flush it thoroughly by running water off a few minutes before placing the pump back in service. Protects seasonally operated pumps against corrosion during shutdowns by "winterizing" them. When corrosion occurs in close-tolerance areas, it can cause the impeller to stick or bind. Protect your clients investment and your reputation! Safe for all types of water pumps and it requires no special rinsing at start-up.
  • Protects against corrosion and ends-pump impeller binding
  • Convenient aerosol package
  • Safe for all types of water pumps
  • One can is enough for most pumps
  • Requires no special rinsing at startup
  • Protects pool pumps throughout the winter
  • This product has been authorized by the USDA for use in federally inspected meat and poultry plants
  • 95% volatile
  • Level 1 heat of combustion
  • 13 cm flame height, 4 - 5 sec flammability duration Foam-in shut down corrosion protection for all types of pumps any pump that is shut down and drained part of the time should be safeguarded with aerosol pump protector. Pumps used in cooling towers, swimming pools and vacation homes, auxiliary pumps, marine and industrial pumps can develop corrosion deposits on the impeller and other close-tolerance areas during shut down, causing the pump to bind. Aerosol pump protector prevents this corrosion and lubricates the pump so that it starts right up every time! pump protector is water soluble and will not cause any foaming problem when the pump is started. If the pump is used for drinking water, flush it thoroughly by running water off a few minutes before placing the pump back in service. Protects seasonally operated pumps against corrosion during shutdowns by "winterizing" them. When corrosion occurs in close-tolerance areas, it can cause the impeller to stick or bind. Protect your clients investment and your reputation! Safe for all types of water pumps and it requires no special rinsing at start-up.
Item#:
4299-T8
Manufacturer Item:
4299-T8
Manufacturer:
NU-CALGON
Copeland Ultra 22CC 998-E022-01 Polyolester Oil, 1 gal
Sid Harvey Item #:998E02201: Replaces Part #:'s : LE32S1
Item#:
998E02201
Manufacturer Item:
998-E022-01
Manufacturer:
COPELAND
Utility Enterprises Plasti-Seal Gloo 12-992 PVC Cement, 16 oz, Clear
  • Regular bodied, fast-set
  • Recommended potable water and DWV (drain/waste/vent) systems
Sid Harvey Item #:12-992: Replaces Part #:'s : 10037
Item#:
12-992
Manufacturer Item:
12-992
Manufacturer:
UTILITY ENTERPRISES
The brake cleaner to use where compliance calls for a chlorine-free product. Formulated to quickly remove brake fluid, grease, oil, and other contaminants from brake linings and pads.
Item#:
5YK76
Manufacturer Item:
05084
Manufacturer:
NATIONAL PARTS SUPPLY
Highside Leak Lock is a state-of-the-art high strength, pipe joint sealant consisting of chemically resistant film formers, plasticizers, reinforcing fillers and solvents, useable on all clean metal or plastic surfaces.
  • For use with pressures ranges from full vacuum to 10000 psi
  • Never hardens and never becomes brittle
  • Sticks to all clean surfaces
  • Non-toxic
Sid Harvey Item #:F3-70: Replaces Part #:'s : B10-853
Item#:
F3-70
Manufacturer Item:
10001
Manufacturer:
SEALED UNIT PARTS CO, INC
Item#:
SHWIPES
Manufacturer Item:
SHWIPES
Manufacturer:
SID HARVEY INDUSTRIES INC.
Diversitech EBBL377 Spray Paint, Gloss Black
Item#:
F4-21
Manufacturer Item:
EBBL377
Manufacturer:
DIVERSIFIED BRANDS
Sid Harvey F1-55A Spruce-Up Very Fast Drying Spray Degreaser
  • Non-Flammable
  • Non-Corrosive
  • Non-Conductive
Item#:
F1-55A
Manufacturer Item:
403510A
Manufacturer:
SID HARVEY INDUSTRIES INC.
Evap Foam "no rinse" is a high performance, heavy duty detergent, specifically formulated with special surfactants and alkaline cleaners that have been developed into a foaming, no-rinse product. The aerosol product can be sprayed either right side up or upside down, and is ideal for use on most coils, but particularly suited for cooling or evaporator coils.
  • Cleans and deodorizes
  • Easily sprayed from any angle right side up or upside down
  • Self-rinsing, fast breaking foam
  • Biodegradable
  • Can be used with talon aerosol wand (4776-0)
Sid Harvey Item #:4171-75: Replaces Part #:'s : 4743
Item#:
4171-75
Manufacturer Item:
4171-75
Manufacturer:
NU-CALGON
Use Zep carb cleaner to remove dirt, gum and varnish deposits from engine carburetors. Our carb cleaner frees sticky valves, stuck heat risers and throttle linkages. Start your engine easier and improve fuel efficiency by periodically applying Zep carb cleaner to your engine carburetor, throttle bodies, PCV valves, linkages, heat valves and automatic chokes. Zep carb cleaner is safe to use on cars, trucks, boats, lawnmowers. There's no lead or silicone in this formula, and it will not harm oxygen sensors, catalytic converters or fuel injectors.
Item#:
1047995
Manufacturer Item:
1047995
Manufacturer:
ZEP SALES & SERVICE
|◀ 1 - 12 of 781 ▶|
View: